Nissan Sentra. Instruction — part 100
AV-392
< DTC/CIRCUIT DIAGNOSIS >
[NAVIGATION WITH BOSE]
AUXILIARY INPUT JACK
AUXILIARY INPUT JACK
Diagnosis Procedure
INFOID:0000000009759061
Regarding Wiring Diagram information, refer to
.
1.
CHECK AUX JACK HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect AV control uint connector M101 and AUX jack connector M133.
3. Check continuity between AV control uint connector M101 and AUX jack connector M133.
4. Check continuity between AV control uint connector M101 and ground.
Is the inspection result normal?
YES
>> Replace the AUX jack. Refer to
AV-416, "Removal and Installation"
NO
>> Repair or replace harness or connectors.
AV control uint
AUX jack
Continuity
Connector
Terminal
Connector
Terminal
M101
30
M133
1
Yes
32
4
31
3
AV control uint
—
Continuity
Connector
Terminal
M101
30
Ground
No
32
AV
MULTI AV SYSTEM
AV-393
< SYMPTOM DIAGNOSIS >
[NAVIGATION WITH BOSE]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
SYMPTOM DIAGNOSIS
MULTI AV SYSTEM
Symptom Table
INFOID:0000000009759062
RELATED TO AUDIO
Symptoms
Check items
Probable malfunction location
The disk cannot be removed.
AV control unit
Malfunction in AV control unit.
Refer to
.
No sound comes out or the level of the
sound is low.
No sound from all speakers.
• Speaker circuit shorted to ground.
Refer to
• Bose amp. ON signal circuit malfunction.
Refer to
.
• Bose speaker amp. power supply and
ground circuits malfunction.
Refer to
.
Only a certain speaker (front door speaker
LH, front door speaker RH, front tweeter
LH, front tweeter RH, rear door speaker LH,
rear door speaker RH, rear woofer LH, rear
woofer RH) does not output sound.
• Poor connector connection of speaker.
• Sound signal circuit malfunction between
AV control unit and Bose speaker amp.
Refer to:
-
door speaker).
-
tweeter).
-
door speaker).
-
woofer).
• Sound signal circuit malfunction between
Bose speaker amp. and speaker.
Refer to:
-
door speaker).
-
tweeter).
-
door speaker).
-
woofer).
• Malfunction in speaker.
Refer to:
-
AV-408, "Removal and Installation"
(front
door speaker).
-
AV-407, "Removal and Installation"
(front
tweeter).
-
AV-409, "Removal and Installation"
door speaker).
-
AV-410, "Removal and Installation"
woofer).
• Malfunction in AV control unit.
Refer to
.
• Malfunction in Bose speaker amp.
Replace Bose speaker amp. Refer to
AV-394
< SYMPTOM DIAGNOSIS >
[NAVIGATION WITH BOSE]
MULTI AV SYSTEM
Noise is mixed with audio.
Noise comes out from all speakers.
• Malfunction in AV control unit.
• Malfunction in Bose speaker amp.
Replace Bose speaker amp. Refer to
417, "Removal and Installation"
Noise comes out only from a certain speak-
er (front door speaker LH, front door speak-
er RH, front tweeter LH, front tweeter RH,
rear door speaker LH, rear door speaker
RH, rear woofer LH, rear woofer RH).
• Poor connector connection of speaker.
• Sound signal circuit malfunction between
AV control unit and Bose speaker amp.
Refer to:
-
(front
door speaker).
-
(front
tweeter).
-
(rear
door speaker).
-
(rear
woofer).
• Sound signal circuit malfunction between
Bose speaker amp. and speaker.
Refer to:
-
(front
door speaker).
-
(front
tweeter).
-
(rear
door speaker).
-
(rear
woofer).
• Malfunction in speaker.
• Poor Installation of speaker (e.g. back-
lash and looseness).
Refer to:
-
AV-408, "Removal and Installation"
door speaker).
-
AV-407, "Removal and Installation"
tweeter).
-
AV-409, "Removal and Installation"
(rear
door speaker).
-
AV-410, "Removal and Installation"
(rear
woofer).
• Malfunction in AV control unit.
• Malfunction in Bose speaker amp.
Replace Bose speaker amp. Refer to
417, "Removal and Installation"
Noise is mixed with radio only (when the ve-
hicle hits a bump or while driving over bad
roads)
Poor connector connection of antenna or
antenna feeder.
Refer to
.
No radio reception or poor reception.
• Other audio sounds are normal.
• Any radio station cannot be received or
poor reception is caused even after mov-
ing to a service area with good reception
(e.g. a place with clear view and no ob-
stacles generating external noises).
• Antenna amp. ON signal circuit malfunc-
• Poor connector connection of antenna or
Symptoms
Check items
Probable malfunction location
AV
MULTI AV SYSTEM
AV-395
< SYMPTOM DIAGNOSIS >
[NAVIGATION WITH BOSE]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
RELATED TO HANDS-FREE PHONE
• Before performing diagnosis, confirm that the cellular phone being used by the customer is compatible with
the vehicle.
• It is possible that a malfunction is occurring due to a version change of the phone even though the phone is
a compatible type. This can be confirmed by changing the cellular phone to another compatible type, and
check that it operates normally. It is important to determine whether the cause of the malfunction is the vehi-
cle or the cellular phone.
Check Compatibility
1. Make sure the customer’s Bluetooth
®
related concern is understood.
2. Verify the customer’s concern.
NOTE:
The customer’s phone may be required, depending upon their concern.
3. Write down the customer’s phone brand, model and service provider.
NOTE:
It is necessary to know the service provider. On occasion, a given phone may be on the approved list with
one provider, but may not be on the approved list with other providers.
4. Go to “www.nissanusa.com/bluetooth/”.
a. Using the website’s search engine, find out if the customer’s phone is on the approved list.
b. If the customer’s phone is NOT on the approved list:
Stop diagnosis here. The customer needs to obtain a Bluetooth
®
phone that is on the approved list before
any further action.
c. If the feature related to the customer’s concern shows as “N” (not compatible):
Stop diagnosis here. If the customer still wants the feature to function, they will need to get an approved
phone showing the feature as “Y” (compatible) in the “Basic Features”.
d. If the feature related to the customer’s concern shows as “Y” (compatible):
Perform diagnosis as per the following table.
No satellite radio reception.
There is malfunction in the CONSULT self
diagnosis result.
Refer to
.
• Malfunction in antenna, antenna feeder
or AV control unit. Perform DTC diagno-
sis.
Refer to
.
• Poor continuity in antenna feeder.
• Poor connector connection of antenna or
antenna feeder.
Refer to
.
There is no malfunction in the CONSULT
self diagnosis result.
Refer to
.
• Poor continuity in antenna feeder.
• Poor connector connection of antenna or
antenna feeder.
• Loose satellite radio antenna mounting
nut.
Refer to
.
Buzz/rattle sound from speaker
The majority of buzz/rattle sounds are not
indicative of an issue with the speaker, usu-
ally something nearby the speaker is caus-
ing the buzz/rattle.
Refer to "SQUEAK AND RATTLE TROU-
BLE DIAGNOSIS" in the appropriate interi-
or trim section.
Symptoms
Check items
Probable malfunction location
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст