Nissan Quest E52. Instruction — part 29
MEMORY INDICATE DOES NOT OPERATE
ADP-109
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
K
L
M
A
B
ADP
N
O
P
MEMORY INDICATE DOES NOT OPERATE
Diagnosis Procedure
INFOID:0000000009649706
1.
CHECK SEAT MEMORY SWITCH INDICATOR
Check seat memory switch indicator.
Refer to
ADP-98, "Component Function Check"
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Repair or replace the malfunction parts.
2.
CONFIRM THE OPERATION
Confirm the operation again.
Is the result normal?
YES
>> Check intermittent incident. Refer to
GI-42, "Intermittent Incident"
.
NO
>> GO TO 1.
ADP-110
< SYMPTOM DIAGNOSIS >
NORMAL OPERATING CONDITION
NORMAL OPERATING CONDITION
Description
INFOID:0000000009649707
The following symptoms are normal operations, and they do not indicate a malfunction.
Symptom
Cause
Action to take
Reference page
Entry/exit assist function do not
operate.
No initialization has been performed.
Perform initialization.
Entry/exit assist function is disabled.
NOTE:
Entry/exit assist function is set to ON be-
fore delivery (initial setting).
Change the settings.
Entry assist function does not op-
erate.
Instruction operation with power seat switch
was performed after exit assist function
execution.
Perform the entry as-
sist function.
Lumbar support does not per-
form memory operation.
The lumbar support system are con-
trolled independently with no link to the
automatic drive positioner system.
—
Memory function, entry/exit as-
sist function, or Intelligent Key in-
terlock function does not
operate.
The operating conditions are not fulfilled.
Fulfill the operation
conditions.
Memory function :
Entry assist function :
Exit assist function :
Intelligent Key interlock
function :
DRIVER SEAT CONTROL UNIT
ADP-111
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
K
L
M
A
B
ADP
N
O
P
REMOVAL AND INSTALLATION
DRIVER SEAT CONTROL UNIT
Removal and Installation
INFOID:0000000009649708
REMOVAL
1.
Remove driver seat. Refer to
SE-102, "Removal and Installa-
2.
Remove screws (A), and then remove driver seat control unit (2)
from seat cushion frame (1)
INSTALLATION
Install in the reverse order of removal.
NOTE:
After installing the driver seat, perform additional service when replacing control unit. Refer to
JMJIA4721ZZ
ADP-112
< REMOVAL AND INSTALLATION >
AUTOMATIC DRIVE POSITIONER CONTROL UNIT
AUTOMATIC DRIVE POSITIONER CONTROL UNIT
Removal and Installation
INFOID:0000000009649709
REMOVAL
1.
Remove instrument lower panel RH. Refer to
2.
Remove screw (A), and then remove automatic drive positioner
control unit (2) from bracket (1).
INSTALLATION
Install in the reverse order of removal.
NOTE:
After installing the driver seat, perform additional service when replacing control unit. Refer to
JMJIA6178ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст