Nissan Quest E52. Instruction — part 13
DIAGNOSIS AND REPAIR WORK FLOW
ADP-45
< BASIC INSPECTION >
C
D
E
F
G
H
I
K
L
M
A
B
ADP
N
O
P
YES
>> INSPECTION END
Symptom is detected.>> GO TO 5.
DTC is detected.>> GO TO 6.
ADP-46
< BASIC INSPECTION >
ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL
ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMI-
NAL
Description
INFOID:0000000009649615
Each function is reset to the following condition when the battery terminal is disconnected.
*
: Default value is 40 mm.
NOTE:
Notice that disconnecting the battery when detected DTC are present will erase the DTC memory.
Work Procedure
INFOID:0000000009649616
1.
SYSTEM INITIALIZATION
Perform system initialization. Refer to
>> GO TO 2.
2.
MEMORY STORAGE
Perform memory storage. Refer to
>> GO TO 3.
3.
INTELLIGENT KEY INTERLOCK STORAGE
Perform Intelligent Key interlock storage. Refer to
>> GO TO 4.
4.
SYSTEM SETTING
Perform system setting. Refer to
>> END
Function
Condition
Procedure
Memory (Seat, mirror)
Erased
Perform storing
Entry/exit assist
ON
Perform initialization
Set slide amount
*
Intelligent Key interlock
Erased
Perform initialization
Perform storing
ADDITIONAL SERVICE WHEN REMOVING DRIVER SEAT CONTROL UNIT
ADP-47
< BASIC INSPECTION >
C
D
E
F
G
H
I
K
L
M
A
B
ADP
N
O
P
ADDITIONAL SERVICE WHEN REMOVING DRIVER SEAT CONTROL
UNIT
Description
INFOID:0000000009649617
Each function is reset to the following condition when the driver seat control unit is replaced.
*
: Default value is 40 mm.
NOTE:
Notice that disconnecting the battery when detected DTC are present will erase the DTC memory.
Work Procedure
INFOID:0000000009649618
1.
SYSTEM INITIALIZATION
Perform system initialization. Refer to
>> GO TO 2.
2.
MEMORY STORAGE
Perform memory storage. Refer to
>> GO TO 3.
3.
INTELLIGENT KEY INTERLOCK STORAGE
Perform Intelligent Key interlock storage. Refer to
>> GO TO 4.
4.
SYSTEM SETTING
Perform system setting. Refer to
>> END
Function
Condition
Procedure
Memory (Seat, mirror)
Erased
Perform storing
Entry/exit assist
ON
Perform initialization
Set slide amount
*
Intelligent Key interlock
Erased
Perform initialization
Perform storing
ADP-48
< BASIC INSPECTION >
SYSTEM INITIALIZATION
SYSTEM INITIALIZATION
Description
INFOID:0000000009649619
Always perform the initialization when the battery terminal is disconnected or the driver seat control unit is
replaced.
The entry/exit assist function will not operate normally if no initialization is performed.
Work Procedure
INFOID:0000000009649620
1.
STEP 1
There are two initialization methods.
Which method do you use?
With door switch>>GO TO 2.
With vehicle speed>>GO TO 3.
2.
STEP 2-A (WITH DOOR SWITCH)
1.
Turn ignition switch from ACC to OFF position.
2.
Front door switch (driver side) is ON (open)
→
OFF (close)
→
ON (open).
>> END
3.
STEP 2-B (WITH VEHICLE SPEED)
Drive the vehicle at more than 25 km/h (16 MPH).
>> END
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст