Nissan Quest E52. Instruction — part 783
INL-12
< SYSTEM DESCRIPTION >
SYSTEM
SYSTEM DIAGRAM (WITHOUT AUTOMATIC SLIDE DOOR)
OUTLINE
• Interior room lamp battery saver is controlled by BCM.
• BCM turns applicable lamps OFF depending on the vehicle condition. This function prevents the battery
from over-discharging if the driver neglects turning OFF the any lamps.
Applicable lamps
• Map lamp
• Personal lamp
• Luggage room lamp
• Automatic back door close switch illumination
• Step lamp
• Vanity mirror lamp
INTERIOR ROOM LAMP BATTERY SAVER FUNCTION
• When the ignition switch is turned to a position other than ON, BCM operates the timer for a period of time to
cut the interior room lamp power supply.
• BCM restart the timer when any of the following signals changes while operating the timer.
- Ignition switch status
- Door switch signal (ALL)
- Door lock/unlock signal (remote keyless entry receiver, each door request switch, door lock and unlock
switch, door key cylinder switch)
• BCM provides the interior room lamp power supply continuously when the ignition switch position is ON.
NOTE:
Each function of interior room lamp battery saver can be set by CONSULT. Refer to
SAVER : CONSULT Function (BCM - BATTERY SAVER)"
.
JMLIA2209GB
SYSTEM
INL-13
< SYSTEM DESCRIPTION >
C
D
E
F
G
H
I
J
K
M
A
B
INL
N
O
P
INTERIOR ROOM LAMP BATTERY SAVER SYSTEM : Circuit Diagram
INFOID:0000000009653469
JMLIA2125GB
INL-14
< SYSTEM DESCRIPTION >
SYSTEM
ILLUMINATION CONTROL SYSTEM
JMLIA2128GB
SYSTEM
INL-15
< SYSTEM DESCRIPTION >
C
D
E
F
G
H
I
J
K
M
A
B
INL
N
O
P
ILLUMINATION CONTROL SYSTEM : System Description
INFOID:0000000009653470
SYSTEM DIAGRAM
OUTLINE
Each illumination lamp is controlled by each function of BCM, IPDM E/R and combination meter.
Control by BCM
• Combination switch reading function
• Headlamp control function
Control by IPDM E/R
• Relay control function
Control by combination meter
• Meter illumination control function (Refer to
MWI-17, "METER ILLUMINATION CONTROL : System Descrip-
ILLUMINATION CONTROL
• BCM detects the combination switch condition by the combination switch reading function.
• BCM transmits position light request signal to IPDM E/R and combination meter according to tail lamp ON
condition.
Tail lamp ON condition
- Lighting switch 1ST
- Lighting switch 2ND
- Lighting switch AUTO, and the auto light function ON judgment
- Lighting switch AUTO, with the front fog lamp switch ON and the ignition switch ON
• IPDM E/R turns the integrated tail lamp relay ON according to position light request signal. It provides the
power supply to each illumination lamp.
• Combination meter enters in the nighttime mode according to position light request signal. Under the night-
time mode the combination meter controls the illuminance by controlling each illumination lamp (ground
side).
JMLIA2210GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст