Nissan Quest E52. Instruction — part 187
AV
ANTENNA AMP.
AV-627
< REMOVAL AND INSTALLATION >
[BOSE AUDIO WITH NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
ANTENNA AMP.
Removal and Installation
INFOID:0000000009652421
REMOVAL
1.
Remove rear pillar garnish RH. Refer to
INT-27, "REAR PILLAR GARNISH : Removal and Installation"
2.
Remove screw and disconnect connector, and remove antenna amp.
INSTALLATION
Install in the reverse order of removal.
AV-628
< REMOVAL AND INSTALLATION >
[BOSE AUDIO WITH NAVIGATION]
SATELLITE RADIO ANTENNA
SATELLITE RADIO ANTENNA
Exploded View
INFOID:0000000009652422
REMOVAL
DISASSEMBLY
Removal and Installation
INFOID:0000000009652423
REMOVAL
1.
Remove rear upper ventilator duct 2. Refer to
.
2.
Disconnect antenna feeder connector.
3.
Remove nut, and remove satellite radio antenna and the cover from the vehicle as a single unit.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
If the satellite radio antenna mounting nut is tightened looser than the specified torque, then this will
lower the sensitivity of the antenna. On the other hand, if the nut is tightened tighter than the specified
torque, then this will deform the roof panel.
Disassembly and Assembly
INFOID:0000000009652424
DISASSEMBLY
Insert cloth-covered driver into gaps between satellite radio antenna and the cover, and remove the cover from
satellite radio antenna.
ASSEMBLY
Assemble in the reverse order of disassembly.
JSNIA3188ZZ
1.
Satellite radio antenna
:
Vehicle front
:
N·m (kg-m, in-fb)
JSNIA3284ZZ
1.
Satellite radio antenna
2.
Cover
:
Pawl
AV
GPS ANTENNA
AV-629
< REMOVAL AND INSTALLATION >
[BOSE AUDIO WITH NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
GPS ANTENNA
Feeder Layout
INFOID:0000000009652425
: Indicates that the part is connected at points with same symbol in actual vehicle.
Removal and Installation
INFOID:0000000009652426
REMOVAL
JSNIA4207GB
AV-630
< REMOVAL AND INSTALLATION >
[BOSE AUDIO WITH NAVIGATION]
GPS ANTENNA
1.
Remove AV control unit. Refer to
AV-610, "Removal and Installation"
2.
Remove front display unit. Refer to
AV-611, "Removal and Installation"
3.
Remove cup holder assembly. Refer to
IP-14, "Removal and Installation"
4.
Remove GPS antenna feeder clips.
5.
Remove screw to remove GPS antenna.
INSTALLATION
Install in the reverse order of removal.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст