Nissan Quest E52. Instruction — part 289
CO-26
< REMOVAL AND INSTALLATION >
WATER OUTLET AND WATER PIPING
WATER OUTLET AND WATER PIPING
Exploded View
INFOID:0000000009650557
1.
Gasket
2.
Water connector
3.
O-ring
4.
Water bypass pipe
5.
Clamp
6.
Water hose
7.
Clamp
8.
Water hose
9.
Bracket
10. Clamp
11.
Water hose
12.
Heater thermostat
13. Clamp
14.
Water hose
15.
Heater pipe
16. O-ring
17.
Clamp
18.
Water hose
19. Clamp
20.
Heater hose
21.
Clamp
22. Clip
23.
Heater hose
24.
Clamp
25. Heater hose
26.
Air bleeder plug
27.
O-ring
28. Heater pipe
29.
Heater hose
30.
Clamp
31. Clamp
32.
Water hose
33.
Gasket
34. Engine coolant temperature sensor
35.
Gasket
36.
Water outlet
37. Bracket
A.
To oil cooler
B.
To radiator
C.
To CVT fluid warmer
D.
To electric throttle control actuator
E.
To heater core
F.
To rear heater
: Always replace after every disassembly.
JPBIA4661GB
WATER OUTLET AND WATER PIPING
CO-27
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
L
M
A
CO
N
P
O
Removal and Installation
INFOID:0000000009650558
REMOVAL
1.
Remove air duct (inlet), air cleaner cases (upper and lower) with mass air flow sensor and air duct assem-
bly. Refer to
.
2.
Remove engine cover. Refer to
.
3.
Drain engine coolant from radiator drain plug at the bottom of radiator, and from water drain plug at the
front of cylinder block. Refer to
and
.
CAUTION:
• Perform this step when the engine is cold.
• Never spill engine coolant on drive belt.
4.
Remove battery and battery tray. Refer to
PG-105, "Removal and Installation"
5.
Remove CVT fluid charging pipe and CVT fluid level gauge. Refer to
6.
Remove oil level gauge. Refer to
7.
Move CVT control cable aside. Refer to
8.
Remove vacuum tube (front) mounting bolt from water outlet. Refer to
.
9.
Remove radiator hose (upper) from water outlet.
10. Remove water hoses and heater hoses.
11. Remove harness bracket.
12. Disconnect harness connectors, and move harness to aside.
13. Remove engine coolant temperature sensor if necessary.
CAUTION:
Be careful not to damage engine coolant temperature sensor.
14. Remove reservoir tank. Refer to
.
15. Remove alternator bracket. Refer to
16. Remove water outlet, heater pipe, water bypass pipe and water connector.
INSTALLATION
CAUTION:
Do not reuse O-rings.
Note the following, and install in the reverse order of removal.
• Securely insert each hose, and install clamp at a position where it does not interfere with the pipe bulge.
• When inserting water bypass pipe and heater pipe into water connector, apply neutral detergent to O-ring.
Inspection
INFOID:0000000009650559
INSPECTION AFTER INSTALLATION
• Check for leakage of engine coolant using the radiator cap tester adapter (commercial service tool) and the
radiator cap tester (commercial service tool). Refer to
.
• Start and warm up the engine. Visually check that there is no leakage of engine coolant.
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
CO-28
< SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
Periodical Maintenance Specification
INFOID:0000000009650560
ENGINE COOLANT CAPACITY (APPROXIMATE)
Unit:
(US qt, lmp qt)
Radiator
INFOID:0000000009650561
Unit: kPa (kg/cm
2
, psi)
Thermostat
INFOID:0000000009650562
Standard
Engine coolant capacity (With reservoir tank at “MAX” level)
11.3 (12, 10)
Reservoir tank
0.75 (6/8, 5/8)
Cap relief pressure
Standard
122.3 - 151.7 (1.2 - 1.5, 17.7 - 22.0)
Limit
108 (1.1, 15.6)
Leakage test pressure
156 (1.59, 22.6)
Valve opening temperature
80.5 - 83.5
°
C (177 - 182
°
F)
Maximum valve lift
8.6 mm/95
°
C (0.339 in/203
°
F)
Valve closing temperature
77
°
C (171
°
F)
DAS-1
CRUISE CONTROL & DRIVER ASSISTANCE
C
D
E
F
G
H
I
J
K
L
M
B
DAS
SECTION
DAS
N
P
A
CONTENTS
DRIVER ASSISTANCE SYSTEM
BSW
PRECAUTION . . . . . . . . . . . ...
PRECAUTIONS . . . . . . . . . . . . ...
Precautions for Removing Battery Terminal . . .....
Precaution for BSW System Service . . . . . .....
SYSTEM DESCRIPTION . . . . . . . ..
COMPONENT PARTS . . . . . . . . . .
Component Parts Location . . . . . . . . . ....
BSW Control Module . . . . . . . . . . . .....
Side Radar LH/RH . . . . . . . . . . . . ....
BSW Indicator LH/RH . . . . . . . . . . . ...
BSW Switch . . . . . . . . . . . . . . . ..
Combination Meter . . . . . . . . . . . . ....
ABS Actuator and Electric Unit (Control Unit) . . ...
BCM . . . . . . . . . . . . . . . . . . ..
TCM . . . . . . . . . . . . . . . . . . ..
ECM . . . . . . . . . . . . . . . . . . ..
SYSTEM . . . . . . . . . . . . . . . ..
System Description . . . . . . . . . . . . ...
Circuit Diagram . . . . . . . . . . . . . ...
Fail-safe (BSW Control Module) . . . . . . . .
Fail-safe (Side Radar) . . . . . . . . . . . .
OPERATION . . . . . . . . . . . . . ...
Switch Name and Function . . . . . . . . . .
System Display and Warning . . . . . . . . ..
HANDLING PRECAUTION . . . . . . . .
Precautions for Blind Spot Warning . . . . . .
DIAGNOSIS SYSTEM (BSW CONTROL
MODULE) . . . . . . . . . . . . . . ...
CONSULT Function (BSW) . . . . . . . . . .
DIAGNOSIS SYSTEM (SIDE RADAR LH) . ...
CONSULT Function (SIDE RADAR LEFT) . . . .
DIAGNOSIS SYSTEM (SIDE RADAR RH) . ...
CONSULT Function (SIDE RADAR RIGHT) . . ...
ECU DIAGNOSIS INFORMATION . . . ..
BSW CONTROL MODULE . . . . . . . ...
Reference Value . . . . . . . . . . . . . ..
Fail-safe . . . . . . . . . . . . . . . . ...
DTC Inspection Priority Chart . . . . . . . . ..
DTC Index . . . . . . . . . . . . . . . ...
SIDE RADAR LH . . . . . . . . . . . ...
Reference Value . . . . . . . . . . . . . ..
Fail-safe . . . . . . . . . . . . . . . . ...
DTC Inspection Priority Chart . . . . . . . . ..
DTC Index . . . . . . . . . . . . . . . ...
SIDE RADAR RH . . . . . . . . . . . ..
Reference Value . . . . . . . . . . . . . ..
Fail-safe . . . . . . . . . . . . . . . . ...
DTC Inspection Priority Chart . . . . . . . . ..
DTC Index . . . . . . . . . . . . . . . ...
WIRING DIAGRAM . . . . . . . . . ..
BLIND SPOT WARNING . . . . . . . . ..
Wiring Diagram . . . . . . . . . . . . . .
BASIC INSPECTION . . . . . . . . ...
DIAGNOSIS AND REPAIR WORK FLOW . ...
Work Flow . . . . . . . . . . . . . . . .
PRE-INSPECTION FOR DIAGNOSIS . . . ..
Inspection Procedure . . . . . . . . . . . ...
ACTION TEST . . . . . . . . . . . . ...
Description . . . . . . . . . . . . . . . ...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст