Nissan Pathfinder (2011 year). Instruction — part 213
DLN-242
< ECU DIAGNOSIS INFORMATION >
[TRANSFER: TX15B]
TRANSFER CONTROL UNIT
CAUTION:
When using a circuit tester to measure voltage for inspection, be sure not to extend forcibly any connector terminals.
NOTE:
Data are reference value and are measured between each terminal and ground.
DTC Index
INFOID:0000000006245104
DTC CHART
47
O
Transfer shift high relay moni-
tor
• Vehicle stopped
• Engine running
• A/T selector le-
ver “N” position
• Brake pedal de-
pressed
4WD shift switch: 2WD to 4H or 4H to 4LO
or 2WD to 4LO (while actuator motor is op-
erating)
Battery voltage
→
0V
Except the above
0V
48
R
Transfer shift low relay moni-
tor
4WD shift switch: 4LO to 4H or 4H to 2WD
or 4LO to 2WD (while actuator motor is op-
erating)
Battery voltage
→
0V
Except the above
0V
50
Y
Transfer shift low relay
4WD shift switch: 4LO to 4H or 4H to 2WD
or 4LO to 2WD
0V
Except the above
Battery voltage
Terminal
Wire
color
Item
Condition
Data (Approx.)
DTC
CONSULT-III
Diagnostic item is detected when...
Reference
[P1801] *INITIAL START*
Due to removal of battery which cuts off power sup-
ply to transfer control unit, self-diagnosis memory
function is suspended.
[P1802]
CONTROL UNIT (1,2,3)
Malfunction is detected in the memory (RAM) sys-
tem of transfer control unit.
[P1803]
Malfunction is detected in the memory (ROM) sys-
tem of transfer control unit.
[P1804]
Malfunction is detected in the memory (EEPROM)
system of transfer control unit.
[P1807] VHCL SPEED SEN·AT
• Malfunction is detected in output shaft revolution
signal that is output from TCM through CAN
communication.
• Improper signal is input while driving.
[P1808] VHCL SPEED SEN·ABS
• Malfunction is detected in vehicle speed signal
that is output from ABS actuator and electric unit
(control unit) through CAN communication.
• Improper signal is input while driving.
[P1809] CONTROL UNIT 4
AD converter system of transfer control unit is mal-
functioning.
[P1810] 4L POSI SW TF
Improper signal from 4LO switch is input due to
open or short circuit.
[P1811]
BATTERY VOLTAGE
Power supply voltage for transfer control unit is ab-
normally low while driving.
[P1813] 4WD MODE SW
More than two switch inputs are simultaneously de-
tected due to short circuit of 4WD shift switch.
[P1814] 4WD DETECT SWITCH
Improper signal from wait detection switch is input
due to open or short circuit.
[P1816] PNP SW/CIRC
When transmission range switch signal is malfunc-
tion or communication error between the modules.
2011 Pathfinder
TRANSFER CONTROL UNIT
DLN-243
< ECU DIAGNOSIS INFORMATION >
[TRANSFER: TX15B]
C
E
F
G
H
I
J
K
L
M
A
B
DLN
N
O
P
NOTE:
If “SHIFT ACT POSI SW [P1818]” or “SHIFT ACT CIR [P1819]” is displayed, first erase self-diagnostic results. (“SHIFT ACT POSI SW
[P1818]” or “SHIFT ACT CIR [P1819]” may be displayed after installing transfer control unit or transfer assembly.)
FLASH CODE CHART
[P1817] SHIFT ACTUATOR
• Motor does not operate properly due to open or
short circuit in actuator motor.
• Malfunction is detected in the actuator motor.
(When 4WD shift switch is operated and actuator
motor is not operated)
• Malfunction is detected in transfer shift high relay
or transfer shift low relay.
[P1818] SHIFT ACT POSI SW
• Improper signal from actuator position switch is
input due to open or short circuit.
• Malfunction is detected in actuator position
switch.
[P1819] SHIFT ACT CIR
• Malfunction is detected in transfer shut off relay
1 and transfer shut off relay 2.
• Malfunction occurs in transfer control device
drive circuit.
[P1820] ENGINE SPEED SIG
• Malfunction is detected in engine speed signal
that is output from ECM through CAN communi-
cation.
• Improper signal is input while driving.
[U1010] CONTROL UNIT (CAN)
Detecting error during the initial diagnosis of CAN
controller of transfer control unit.
DTC
CONSULT-III
Diagnostic item is detected when...
Reference
Flashing pattern
Item
Diagnostic item is detected when...
Reference
2
Output shaft revolution
signal (from TCM)
• Malfunction is detected in output shaft revo-
lution signal that is output from TCM through
CAN communication.
• Improper signal is input while driving.
3
Vehicle speed signal
(from ABS)
• Malfunction is detected in vehicle speed sig-
nal that is output from ABS actuator and
electric unit (control unit) through CAN com-
munication.
• Improper signal is input while driving.
4
CAN communication
Malfunction has been detected from CAN
communication.
5
AD converter
AD converter system of transfer control unit is
malfunctioning.
6
4LO switch
Improper signal from 4LO switch is input due
to open or short circuit.
7
Engine speed signal
• Malfunction is detected in engine speed sig-
nal that is output from ECM through CAN
communication.
• Improper signal is input while driving.
8
Power supply
Power supply voltage for transfer control unit is
abnormally low while driving.
9
4WD shift switch
More than two switch inputs are simultaneous-
ly detected due to short circuit of 4WD shift
switch.
10
Wait detection switch
Improper signal from wait detection switch is
input due to open or short circuit.
2011 Pathfinder
DLN-244
< ECU DIAGNOSIS INFORMATION >
[TRANSFER: TX15B]
TRANSFER CONTROL UNIT
NOTE:
If actuator position switch” or transfer control device” is displayed, first erase self-diagnostic results. (They may be displayed after install-
ing transfer control unit or transfer assembly.)
11
Actuator motor
• Motor does not operate properly due to open
or short circuit in actuator motor.
• Malfunction is detected in the actuator mo-
tor. (When 4WD shift switch is operated and
actuator motor is not operated.)
• Malfunction is detected in transfer shift high
relay or transfer shift low relay.
12
Actuator position
switch
• Improper signal from actuator position
switch is input due to open or short circuit.
• Malfunction is detected in the actuator posi-
tion switch.
13
Transfer control device
• Malfunction is detected in transfer shut off
relay 1 and transfer shut off 2.
• Malfunction occurs in transfer control device
drive circuit.
14
Transmission range
switch signal
Transmission range switch signal is malfunc-
tion or communication error between the mod-
ules.
Repeats flickering
every 0.25 sec.
Data erase display
• Power supply failure of memory back-up.
• Battery is disconnected for a long time.
• Battery performance is poor.
Repeats flickering
every 2 to 5 sec.
—
Circuits that the self-diagnosis covers have no
malfunction.
—
No flickering
Transmission range
switch or 4WD shift
switch
Transmission range switch or 4WD shift switch
circuit is shorted or open.
Flashing pattern
Item
Diagnostic item is detected when...
Reference
2011 Pathfinder
PART TIME 4WD SYSTEM
DLN-245
< WIRING DIAGRAM >
[TRANSFER: TX15B]
C
E
F
G
H
I
J
K
L
M
A
B
DLN
N
O
P
WIRING DIAGRAM
PART TIME 4WD SYSTEM
Wiring Diagram
INFOID:0000000006245103
ABDWA0583GB
2011 Pathfinder
DLN-246
< WIRING DIAGRAM >
[TRANSFER: TX15B]
PART TIME 4WD SYSTEM
ABDWA0586GB
2011 Pathfinder
PART TIME 4WD SYSTEM
DLN-247
< WIRING DIAGRAM >
[TRANSFER: TX15B]
C
E
F
G
H
I
J
K
L
M
A
B
DLN
N
O
P
ABDWA0147GB
2011 Pathfinder
DLN-248
< WIRING DIAGRAM >
[TRANSFER: TX15B]
PART TIME 4WD SYSTEM
ABDIA0891GB
2011 Pathfinder
PART TIME 4WD SYSTEM
DLN-249
< WIRING DIAGRAM >
[TRANSFER: TX15B]
C
E
F
G
H
I
J
K
L
M
A
B
DLN
N
O
P
ABDIA0118GB
2011 Pathfinder
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст