Nissan Cube. Instruction — part 1054
BCM (BODY CONTROL MODULE)
WW-53
< ECU DIAGNOSIS INFORMATION >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
SFT P -MET
Selector lever in any position other than P
Off
Selector lever in P position
On
SFT N -MET
Selector lever in any position other than N
Off
Selector lever in N position
On
ENGINE STATE
Engine stopped
Stop
While the engine stalls
Stall
At engine cranking
Crank
Engine running
Run
S/L LOCK-IPDM
NOTE:
The item is indicated, but not monitored.
Off
S/L UNLK-IPDM
NOTE:
The item is indicated, but not monitored.
Off
S/L RELAY-REQ
NOTE:
The item is indicated, but not monitored.
Off
VEH SPEED 1
While driving
Equivalent to speed-
ometer reading
VEH SPEED 2
While driving
Equivalent to speed-
ometer reading
DOOR STAT-DR
Driver door is locked
LOCK
Wait with selective UNLOCK operation (5 seconds)
READY
Driver door is unlocked
UNLOCK
DOOR STAT-AS
Passenger door is locked
LOCK
Wait with selective UNLOCK operation (5 seconds)
READY
Passenger door is unlocked
UNLOCK
ID OK FLAG
Driver side door is open after ignition switch is turned OFF
(Selector lever is in the P position except for M/T models)
Reset
Ignition switch ON
Set
PRMT ENG STRT
The engine start is prohibited
Reset
The engine start is permitted
Set
PRMT RKE STRT
NOTE:
The item is indicated, but not monitored.
Reset
RKE OPE COUN1
During the operation of the key
Operation frequency
of the key
RKE OPE COUN2
NOTE:
The item is indicated, but not monitored.
—
CONFRM ID ALL
The key ID that the key slot receives is not recognized by any key ID reg-
istered to BCM.
Yet
The key ID that the key slot receives is recognized by any key ID regis-
tered to BCM.
Done
CONFIRM ID4
The key ID that the key slot receives is not recognized by the fourth key ID
registered to BCM.
Yet
The key ID that the key slot receives is recognized by the fourth key ID reg-
istered to BCM.
Done
CONFIRM ID3
The key ID that the key slot receives is not recognized by the third key ID
registered to BCM.
Yet
The key ID that the key slot receives is recognized by the third key ID reg-
istered to BCM.
Done
Monitor Item
Condition
Value/Status
WW-54
< ECU DIAGNOSIS INFORMATION >
BCM (BODY CONTROL MODULE)
CONFIRM ID2
The key ID that the key slot receives is not recognized by the second key
ID registered to BCM.
Yet
The key ID that the key slot receives is recognized by the second key ID
registered to BCM.
Done
CONFIRM ID1
The key ID that the key slot receives is not recognized by the first key ID
registered to BCM.
Yet
The key ID that the key slot receives is recognized by the first key ID reg-
istered to BCM.
Done
NOT REGISTERED
BCM detects registered key ID, or BCM does not detect key ID.
ID OK
BCM detects non-registration key ID.
ID NG
TP 4
The ID of fourth key is not registered to BCM
Yet
The ID of fourth key is registered to BCM
Done
TP 3
The ID of third key is not registered to BCM
Yet
The ID of third key is registered to BCM
Done
TP 2
The ID of second key is not registered to BCM
Yet
The ID of second key is registered to BCM
Done
TP 1
The ID of first key is not registered to BCM
Yet
The ID of first key is registered to BCM
Done
AIR PRESS FL
Ignition switch ON (Only when the signal from the transmitter is received)
Air pressure of front
LH tire
AIR PRESS FR
Ignition switch ON (Only when the signal from the transmitter is received)
Air pressure of front
RH tire
AIR PRESS RR
Ignition switch ON (Only when the signal from the transmitter is received)
Air pressure of rear
RH tire
AIR PRESS RL
Ignition switch ON (Only when the signal from the transmitter is received)
Air pressure of rear
LH tire
ID REGST FL1
ID of front LH tire transmitter is registered
Done
ID of front LH tire transmitter is not registered
Yet
ID REGST FR1
ID of front RH tire transmitter is registered
Done
ID of front RH tire transmitter is not registered
Yet
ID REGST RR1
ID of rear RH tire transmitter is registered
Done
ID of rear RH tire transmitter is not registered
Yet
ID REGST RL1
ID of rear LH tire transmitter is registered
Done
ID of rear LH tire transmitter is not registered
Yet
WARNING LAMP
Tire pressure indicator OFF
Off
Tire pressure indicator ON
On
BUZZER
Tire pressure warning alarm is not sounding
Off
Tire pressure warning alarm is sounding
On
Monitor Item
Condition
Value/Status
BCM (BODY CONTROL MODULE)
WW-55
< ECU DIAGNOSIS INFORMATION >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
TERMINAL LAYOUT
NOTE:
Connector color
• M68, M70: Black
• M69, M71: White
PHYSICAL VALUES
JPMIA1438ZZ
WW-56
< ECU DIAGNOSIS INFORMATION >
BCM (BODY CONTROL MODULE)
Terminal No.
(Wire color)
Description
Condition
Value
(Approx.)
Signal name
Input/
Output
+
−
2
(BR/W)
Ground
Combination switch
INPUT 5
Input
Combination
switch
(Wiper intermit-
tent dial 4)
All switch OFF
0 V
Turn signal switch RH
1.0 V
Lighting switch HI
Lighting switch 1ST
Lighting switch 2ND
2.0 V
3
(GR)
Ground
Combination switch
INPUT 4
Input
Combination
switch
(Wiper intermit-
tent dial 4)
All switch OFF
0 V
Turn signal switch LH
1.0 V
Lighting switch PASS
Lighting switch 2ND
Front fog lamp switch ON
0.8 V
4
(L/Y)
Ground
Combination switch
INPUT 3
Input
Combination
switch
(Wiper intermit-
tent dial 4)
All switch OFF
0 V
Front wiper switch LO
1.0 V
Front wiper switch MIST
Front wiper switch INT
Lighting switch AUTO
PKIB4958J
JPMIA0342JP
PKIB4958J
PKIB4956J
PKIB4958J
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст