Nissan Cube. Instruction — part 116
BRC-114
< REMOVAL AND INSTALLATION >
[VDC/TCS/ABS]
ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
INSTALLATION
Note the following, and install in the reverse order of removal.
• Install, use flare nut crowfoot and torque wrench. Refer to
BR-20, "FRONT : Exploded View"
.
CAUTION:
Never scratch the flare nut and the brake tube.
• Never apply excessive impact to ABS actuator and electric unit (control unit), such as dropping it.
• Never install actuator by holding harness.
• Installing harness connector in the ABS actuator and electric unit (control unit), make sure harness connec-
tor is securely locked.
Adjustment
INFOID:0000000009950053
ADJUSTMENT AFTER INSTALLATION
1.
Refill with new brake fluid and perform the air bleeding. Refer to
BR-11, "Bleeding Brake System"
.
CAUTION:
Never reuse drained brake fluid.
2.
When replacing ABS actuator and electric unit (control unit), make sure adjust neutral position of steering
angle sensor. Refer to
.
YAW RATE/SIDE G SENSOR
BRC-115
< REMOVAL AND INSTALLATION >
[VDC/TCS/ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
N
O
P
YAW RATE/SIDE G SENSOR
Exploded View
INFOID:0000000009950054
Removal and Installation
INFOID:0000000009950055
REMOVAL
CAUTION:
• Never drop or strike yaw rate/side G sensor, or never use power tool etc., because yaw rate/side G
sensor is sensitive to the impact.
1.
Remove front (left side) seat. Refer to
2.
Remove dash side finisher and front kicking plate inner. Refer to
3.
Remove floor trim. Refer to
.
4.
Disconnect yaw rate/side G sensor harness connector.
5.
Remove yaw rate/side G sensor.
INSTALLATION
Note the following, and install in the reverse order of removal.
• Never drop or strike yaw rate/side G sensor, or never use power tool etc., because yaw rate/side G sensor is
sensitive to the impact.
1.
Yaw rate/side G sensor
: Vehicle front
Refer to
JPFIC0047GB
BRC-116
< REMOVAL AND INSTALLATION >
[VDC/TCS/ABS]
STEERING ANGLE SENSOR
STEERING ANGLE SENSOR
Exploded View
INFOID:0000000009950056
Removal and Installation
INFOID:0000000009950057
REMOVAL
1.
Remove spiral cable assembly. Refer to
2.
Remove steering angle sensor from spiral cable assembly.
INSTALLATION
Note the following, and install in the reverse order of removal.
• Never reuse steering angle sensor.
Adjustment
INFOID:0000000009950058
Make sure to adjust neutral position of steering angle sensor. Refer to
1.
Steering angle sensor
: Vehicle front
Refer to
for the symbols in the figure.
JSFIA0237GB
VDC OFF SWITCH
BRC-117
< REMOVAL AND INSTALLATION >
[VDC/TCS/ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
N
O
P
VDC OFF SWITCH
Removal and Installation
INFOID:0000000009950059
REMOVAL
1.
Remove Instrument lower panel LH. Refer to
2.
Remove VDC OFF switch.
INSTALLATION
Install in the reverse order of removal.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст