Nissan Cube. Instruction — part 488
FRONT GRILLE
EXT-17
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
FRONT GRILLE
Exploded View
INFOID:0000000009949374
Removal and Installation
INFOID:0000000009949375
REMOVAL
1.
Fully open hood.
2.
Remove front grille upper side fixing clips.
3.
Disengage front grille mounting clips (B) by rotating 45
°
using a
flat-bladed screwdriver (A) through access hole of front grille (1)
upper while pulling front grill toward vehicle front.
4.
Remove bumper fascia upper fixing clips.
5.
Disengage front grille fixing pawls from back side of front grille while pull front grille horizontally to word
vehicle front, and then remove front grille.
1.
Front grille
2.
Front emblem
: Pawl
JMKIA3796ZZ
JMKIA3818ZZ
EXT-18
< REMOVAL AND INSTALLATION >
FRONT GRILLE
6.
Remove the front emblem after removing front grille.
INSTALLATION
Install in the reverse order of removal.
COWL TOP
EXT-19
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
COWL TOP
Exploded View
INFOID:0000000009949376
Removal and Installation
INFOID:0000000009949377
REMOVAL
1.
Fully open hood assembly.
2.
Remove front wiper arm, and blades (LH/RH). Refer to
WW-147, "Removal and Installation"
.
3.
Remove front fender cover. Refer to
DLK-188, "Removal and Installation"
(with Intelligent Key System) or
DLK-341, "Removal and Installation"
(without Intelligent Key System).
4.
Remove cowl top cover fixing clips.
1.
Cowl top cover seal
2.
Washer nozzle
3.
Cowl top cover cap
4.
Cowl top cover
5.
EPT sealer [t: 3.0 mm (0.118 in)]
6.
Cowl top extension
7.
Wiper motor bracket
8.
Wiper pivot bracket rear
9.
Wiper pivot bracket front
: Clip
: Pawl
: Always replace after every disassembly.
JMKIA4089ZZ
EXT-20
< REMOVAL AND INSTALLATION >
COWL TOP
5.
Pull forward to release cowl top cover from windshield glass.
CAUTION:
When performing the procedure after removing cowl top
cover, cover the lower and of windshield glass with ure-
thane etc.
6.
Disconnect wind washer tube connector.
7.
Remove cowl top cover.
8.
Remove the following parts after removing cowl top cover.
• EPT sealer
• Cowl top cover seal
• Washer tube
• Washer nozzles. Refer to
WW-144, "Removal and Installation"
.
9.
Remove front wiper drive assembly. Refer to
WW-149, "Removal and Installation"
.
10. Remove cowl top extension mounting bolts, and them cowl top extension.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
• Always replace cowl top cover EPT sealer on rear of vehicle with a new one when installing old cowl
top cover.
• After installing, perform adjustment of wiper arm. Refer to
.
JMKIA3819ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст