Nissan Cube. Instruction — part 278
DLK-378
< REMOVAL AND INSTALLATION >
[WITHOUT INTELLIGENT KEY SYSTEM]
DOOR SWITCH
DOOR SWITCH
Exploded View
INFOID:0000000009950837
Removal and Installation
INFOID:0000000009950838
REMOVAL
1.
Remove the door switch mounting bolt (A), and then remove
door switch (1).
INSTALLATION
Install in the reverse order of removal.
1.
Door switch
JMKIA2180ZZ
JMKIA0171ZZ
REMOTE KEYLESS ENTRY RECEIVER
DLK-379
< REMOVAL AND INSTALLATION >
[WITHOUT INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
REMOTE KEYLESS ENTRY RECEIVER
Exploded View
INFOID:0000000009950839
Removal and Installation
INFOID:0000000009950840
REMOVAL
1.
Remove the glove box assembly. Refer to
IP-14, "Removal and Installation"
2.
Remove the remote keyless entry receiver mounting bolt (A),
and then remove remote keyless entry receiver (1).
INSTALLATION
Install in the reverse order of removal.
1.
Remote keyless entry receiver
JMKIA4338ZZ
JMKIA4337ZZ
DLK-380
< REMOVAL AND INSTALLATION >
[WITHOUT INTELLIGENT KEY SYSTEM]
KEYFOB BATTERY
KEYFOB BATTERY
Exploded View
INFOID:0000000009950841
Removal and Installation
INFOID:0000000009950842
REMOVAL
1.
Remove screw (9) on the rear of keyfob.
2.
Place the key with the lower case (8) facing up. Set a screw-driver wrapped with tape between upper case
(1) and lower case (8) and then separate the lower case (8) from the upper case (1).
CAUTION:
• Do not touch the circuit board or battery terminal.
• The keyfob is water-resistant. However, if it does get wet, immediately wipe it dry.
3.
When replacing the circuit board assembly, remove circuit board assembly from the upper case (1).
[Circuit board assembly: Switch rubber (4) + Board surface (5)]
CAUTION:
Do not touch the printed circuits directly.
4.
Remove the battery (6) from the lower case (8) and replace it.
CAUTION:
When replacing battery, keep dirt, grease, and other foreign materials off the electrode contact
area.
5.
After replacement, fit the lower and upper cases together, part (4), (7) and tighten with the screw.
CAUTION:
After replacing the battery, Be sure to check that door locking operates normally using the keyfob.
Refer to
DLK-271, "Component Function Check"
INSTALLATION
Install in the reverse order of removal.
JMKIA1442ZZ
1.
Upper case
2.
Key
3.
Switch cover
4.
Switch rubber
5.
Board surface
6.
Battery
7.
plate
8.
Lower case
9.
Screw
Battery replacement
: Coin-type lithium battery
(CR1620)
EC-1
ENGINE
C
D
E
F
G
H
I
J
K
L
M
SECTION
EC
A
EC
N
O
P
CONTENTS
ENGINE CONTROL SYSTEM
MR18DE
BASIC INSPECTION . . . . . . . . .
DIAGNOSIS AND REPAIR WORK FLOW . . .
Work Flow . . . . . . . . . . . . . . . .....
Diagnostic Work Sheet . . . . . . . . . . .
INSPECTION AND ADJUSTMENT . . . . .
BASIC INSPECTION . . . . . . . . . . . . .
BASIC INSPECTION : Special Repair Require-
ment . . . . . . . . . . . . . . . . . .
ADDITIONAL SERVICE WHEN REPLACING
CONTROL UNIT . . . . . . . . . . . . . .
ADDITIONAL SERVICE WHEN REPLACING
CONTROL UNIT : Description . . . . . . . .
ADDITIONAL SERVICE WHEN REPLACING
CONTROL UNIT : Special Repair Requirement . .
IDLE SPEED . . . . . . . . . . . . . . . ..
IDLE SPEED : Description . . . . . . . . . ..
IDLE SPEED : Special Repair Requirement . . ...
IGNITION TIMING . . . . . . . . . . . . . ..
IGNITION TIMING : Description . . . . . . . ..
IGNITION TIMING : Special Repair Requirement
VIN REGISTRATION . . . . . . . . . . . . .
VIN REGISTRATION : Description . . . . . . .
VIN REGISTRATION : Special Repair Require-
ment . . . . . . . . . . . . . . . . . .
ACCELERATOR PEDAL RELEASED POSITION
LEARNING . . . . . . . . . . . . . . . .
ACCELERATOR PEDAL RELEASED POSITION
LEARNING : Description . . . . . . . . . . .
ACCELERATOR PEDAL RELEASED POSITION
LEARNING : Special Repair Requirement . . . ..
THROTTLE VALVE CLOSED POSITION LEARN-
ING . . . . . . . . . . . . . . . . . . . .
THROTTLE VALVE CLOSED POSITION
LEARNING : Description . . . . . . . . . . .
THROTTLE VALVE CLOSED POSITION
LEARNING : Special Repair Requirement . . . ..
IDLE AIR VOLUME LEARNING . . . . . . . .
IDLE AIR VOLUME LEARNING : Description . . .
IDLE AIR VOLUME LEARNING : Special Repair
Requirement . . . . . . . . . . . . . . .
MIXTURE RATIO SELF-LEARNING VALUE
CLEAR . . . . . . . . . . . . . . . . . ...
MIXTURE RATIO SELF-LEARNING VALUE
CLEAR : Description . . . . . . . . . . . .
MIXTURE RATIO SELF-LEARNING VALUE
CLEAR : Special Repair Requirement . . . . . .
HOW TO SET SRT CODE . . . . . . . .
Description . . . . . . . . . . . . . . . ...
SRT Set Driving Pattern . . . . . . . . . . ..
Work Procedure . . . . . . . . . . . . . ...
HOW TO ERASE PERMANENT DTC . . . ..
Description . . . . . . . . . . . . . . . ...
Work Procedure (Group A) . . . . . . . . . ..
Work Procedure (Group B) . . . . . . . . . ..
SYSTEM DESCRIPTION . . . . . . . .
ENGINE CONTROL SYSTEM . . . . . . ..
System Diagram . . . . . . . . . . . . . .
System Description . . . . . . . . . . . . ..
Component Parts Location . . . . . . . . .
Component Description . . . . . . . . . . ...
MULTIPORT FUEL INJECTION SYSTEM . ...
System Diagram . . . . . . . . . . . . . .
System Description . . . . . . . . . . . . ..
Component Parts Location . . . . . . . . .
Component Description . . . . . . . . . . ...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст