Nissan March K13. Instruction — part 385
HAC-74
< SYMPTOM DIAGNOSIS >
[AUTOMATIC AIR CONDITIONER]
MEMORY FUNCTION DOES NOT OPERATE
MEMORY FUNCTION DOES NOT OPERATE
Description
INFOID:0000000006024079
SYMPTOM
• Memory function dose not operate normally.
• The setting is not maintained (It returns to initial condition).
Inspection Procedure
INFOID:0000000006024080
1.
CHECK MEMORY FUNCTION
1.
Start the engine.
2.
Set the temperature to 32
°
C (90
°
F) by operating the temperature control switch.
3.
Press OFF switch.
4.
Turn the ignition switch OFF.
5.
Turn the ignition switch ON.
6.
Press AUTO switch.
7.
Check that the set temperature is maintained.
Is the inspection result normal?
YES
>> INSPECTION END
NO
>> GO TO 2.
2.
CHECK POWER SUPPLY AND GROUND CIRCUIT OF A/C AUTO AMP.
Check power supply and ground circuit of A/C auto amp. Refer to
Is the inspection result normal?
YES
>> Replace the A/C auto amp.
NO
>> Repair or replace the malfunctioning parts.
A/C CONTROL (A/C AUTO AMP.)
HAC-75
< REMOVAL AND INSTALLATION >
[AUTOMATIC AIR CONDITIONER]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
REMOVAL AND INSTALLATION
A/C CONTROL (A/C AUTO AMP.)
Removal and Installation
INFOID:0000000006024084
REMOVAL
1.
Remove A/C finisher. Refer to
IP-13, "Removal and Installation"
.
2.
Remove mounting screws and then remove A/C control from A/C finisher.
INSTALLATION
Install in the reverse order of removal.
HAC-76
< REMOVAL AND INSTALLATION >
[AUTOMATIC AIR CONDITIONER]
AMBIENT SENSOR
AMBIENT SENSOR
Removal and Installation
INFOID:0000000006024086
REMOVAL
1.
Remove the bumper fascia. Refer to
EXT-11, "Removal and Installation"
.
2.
Disengage the pawl, and then remove ambient sensor from bracket.
3.
Disconnect ambient sensor connector, and then remove the ambient sensor.
INSTALLATION
Install in the reverse order of removal.
IN-VEHICLE SENSOR
HAC-77
< REMOVAL AND INSTALLATION >
[AUTOMATIC AIR CONDITIONER]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
IN-VEHICLE SENSOR
Removal and Installation
INFOID:0000000006024088
REMOVAL
1.
Remove instrument lower finisher RH. Refer to
IP-13, "Removal and Installation"
2.
Remove mounting screw, and then remove in-vehicle sensor from instrument lower finisher RH.
INSTALLATION
Install in the reverse order of removal.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст