Nissan March K13. Instruction — part 642
STARTING SYSTEM (WITH INTELLIGENT KEY)
STR-9
< WIRING DIAGRAM >
C
D
E
F
G
H
I
J
K
L
M
A
STR
N
P
O
WIRING DIAGRAM
STARTING SYSTEM (WITH INTELLIGENT KEY)
Wiring Diagram
INFOID:0000000006057520
For connector terminal arrangements, harness layouts, and alphabets in a
(option abbreviation; if not
described in wiring diagram), refer to
GI-12, "Connector Information"
JCBWM1491GB
STR-10
< WIRING DIAGRAM >
STARTING SYSTEM (WITHOUT INTELLIGENT KEY)
STARTING SYSTEM (WITHOUT INTELLIGENT KEY)
Wiring Diagram
INFOID:0000000006066886
For connector terminal arrangements, harness layouts, and alphabets in a
(option abbreviation; if not
described in wiring diagram), refer to
GI-12, "Connector Information"
JCBWM1491GB
DIAGNOSIS AND REPAIR WORK FLOW
STR-11
< BASIC INSPECTION >
C
D
E
F
G
H
I
J
K
L
M
A
STR
N
P
O
BASIC INSPECTION
DIAGNOSIS AND REPAIR WORK FLOW
Work Flow
INFOID:0000000006057521
OVERALL SEQUENCE
DETAILED FLOW
JPBIA0502GB
STR-12
< BASIC INSPECTION >
DIAGNOSIS AND REPAIR WORK FLOW
NOTE:
If any malfunction is found, immediately disconnect the battery cable from the negative terminal.
1.
CHECK ENGINE START
Crank the engine and check that the engine starts.
Does the engine start?
YES
>> GO TO 2.
NO
>> GO TO 3.
2.
CHECK THAT THE STARTER MOTOR STOPS
Check that the starter motor stops after starting the engine.
Does the starter motor stop?
YES
>> INSPECTION END
NO
>> Replace magnetic switch.
3.
CHECK THE ENGINE SPEED WITH CRANKING
Check that the engine runs at cranking.
Does engine turn by cranking?
YES
>> GO TO 4.
NO
>> GO TO 5.
4.
CHECK THE ENGINE SPEED WITH CRANKING
Check that the engine speed is not low at cranking.
Does engine turn normally?
YES
>> Check ignition/fuel system.
NO
>> Check charge condition, corrosion and connection condition of the battery. Refer to
5.
CHECK STARTER MOTOR ACTIVATION
Check that the starter motor runs at cranking.
Does starter motor turn?
YES
>> GO TO 6.
NO
>> GO TO 7.
6.
CHECK STARTER MOTOR UNIT
1.
Remove starter motor.
2.
Check that the gear shaft of starter motor rotates.
Does gear shaft turn?
YES
>> Check pinion clutch. Refer to
STR-19, "Inspection and Adjustment"
.
NO
>> Check reduction gear, armature and gear shaft.
7.
CHECK POWER SUPPLY CIRCUIT
Check the following conditions.
• Fuse and fusible link
• Charge condition, corrosion and connection condition of the battery. Refer to
Are these inspection results normal?
YES
>> GO TO 8.
NO
>> Repair as needed.
8.
CHECK STARTING SYSTEM WIRING
Check the following.
• “B” terminal circuit. Refer to
.
• “S” terminal circuit. Refer to
.
Are these inspection results normal?
YES
>> GO TO 9.
NO
>> Repair as needed.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст