Nissan Primera P12. Instruction — part 570
LAN-192
[CAN]
CAN SYSTEM (TYPE 32)
CHECK SHEET
PKIA0808E
CAN SYSTEM (TYPE 32)
LAN-193
[CAN]
C
D
E
F
G
H
I
J
L
M
A
B
LAN
CHECK SHEET RESULTS (EXAMPLE)
PKIA0809E
LAN-194
[CAN]
CAN SYSTEM (TYPE 32)
NOTE:
If “NG” is displayed on “CAN COMM” for the diagnosed control unit, replace the control unit.
INSPECTION
Proceed trouble diagnosis according to the check sheet results (example).
Case 1:Replace ECM.
Case 2:Replace ABS actuator and electric unit (control unit).
Case 3:Replace Smart entrance control unit.
Case 4:Check Harness between ABS actuator and electric unit (control unit) and Smart entrance control unit.
Refer to
LAN-195, "Circuit Check Between ABS Actuator and Electric Unit (control unit) and Smart Entrance
.
Case 5:Check ECM Circuit. Refer to
.
Case 6:Check ABS actuator and electric unit (control unit) Circuit. Refer to
LAN-197, "ABS Actuator and Elec-
tric Unit (control unit) Circuit Check"
.
Case 7:Check Smart entrance control unit Circuit. Refer to
LAN-197, "Smart Entrance Control Unit Circuit
.
Case 8:Check Combination meter Circuit. Refer to
LAN-198, "Combination Meter Circuit Check"
.
Case 9:Check CAN communication Circuit. Refer to
LAN-198, "CAN Communication Circuit Check"
.
PKIA0810E
CAN SYSTEM (TYPE 32)
LAN-195
[CAN]
C
D
E
F
G
H
I
J
L
M
A
B
LAN
Circuit Check Between ABS Actuator and Electric Unit (control unit) and Smart
Entrance Control Unit
EKS00AT2
1.
CHECK CONNECTOR
1.
Turn ignition switch OFF.
2.
Disconnect the negative battery cable.
3.
Check following terminals and connector for damage, bend and loose connection. (connector-side and
harness-side)
●
Harness connector E120
●
Harness connector B107
●
Harness connector B101
●
Harness connector M87
OK or NG
OK
>> GO TO 2.
NG
>> Repair terminal or connector.
2.
CHECK HARNESS FOR OPEN CIRCUIT
1.
Disconnect ABS actuator and electric unit (control unit) connector and harness connector E120.
2.
Check continuity between ABS actuator and electric unit (control
unit) harness connector E64 terminals 26 (L), 15 (R) and har-
ness connector E120 terminals 2 (L), 1 (R).
OK or NG
OK
>> GO TO 3.
NG
>> Repair harness.
3.
CHECK HARNESS FOR OPEN CIRCUIT
1.
Disconnect harness connector B101.
2.
Check continuity between harness connector B107 terminals 2
(L), 1 (R) and harness connector B101 terminals 3 (L), 14 (R).
OK or NG
OK
>> GO TO 4.
NG
>> Repair harness.
26(L) – 2(L)
: Continuity should exist.
15(R) – 1(R)
: Continuity should exist.
PKIA0876E
2(L) – 3(L)
: Continuity should exist.
1(R) – 14(R)
: Continuity should exist.
PKIA0877E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст