Nissan Primera P12. Instruction — part 131
TROUBLE DIAGNOSIS
BRC-29
[ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
4.
SYMPTOM CHECK 4
Check that the symptom is reproduce when the engine speed is increased with the vehicle stopped.
Is inspection result OK?
OK
>> GO TO 5.
NG
>>
●
Normal.
CAUTION:
This symptom may appear with vehicle stopped.
5.
SYMPTOM CHECK 5
Check that the symptom is reproduce when any switch of electrical equipment is operated.
Is inspection result OK?
OK
>> Check that there are no radio, antenna, and antenna lead-in wires (including wiring) near control
unit.
NG
>> GO TO 6.
6.
ABS WARNING LAMP INSPECTION
Check that the ABS warning lamp turns on.
Is inspection result OK?
OK
>> Perform the self-diagnosis.
NG
>> GO TO 7.
7.
WHEEL SENSOR INSPECTION
Check the wheel sensor system.
●
Sensor mounting inspection
●
Sensor pick-up inspection for iron chips (e.g. Number of teeth, damaged teeth)
●
Sensor connector engagement inspection
●
Wheel sensor path harness and connector inspection
Is inspection result OK?
OK
>> Normal
NG
>> Wheel sensor and rotor lines repair
BRC-30
[ABS]
WHEEL SENSORS
WHEEL SENSORS
PFP:47910
Removal and Installation
EFS002WI
CAUTION:
●
Be careful not to damage sensor edge and rotor tooth. Before removing front or rear wheel hub,
remove wheel sensor to avoid sensor wiring damage. Otherwise, sensor may be deactivated.
●
When removing sensor, avoid rotating it as much as possible. Do not forcibly pull sensor harness.
●
When installing, check sensor pick-up and mounting hole for foreign material such as iron chips.
Check no foreign material has been caught in sensor rotor. Remove any foreign material found.
Tighten mounting bolts and nuts to the specified torque.
SFIA0421E
SENSOR ROTOR
BRC-31
[ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
SENSOR ROTOR
PFP:47970
Removal and Installation
EFS002WJ
REMOVAL
Front
1.
Remove drive shaft. Refer to
.
2.
Remove sensor rotor from drive shaft. Refer to
.
Rear
1.
Remove wheel hub. Refer to
.
2.
Remove sensor rotor from wheel hub. Refer to
.
INSTALLATION
Front
1.
Install sensor rotor to drive shaft. Refer to
.
2.
Connect drive shaft. Refer to
.
Rear
1.
Install sensor rotor to wheel hub. Refer to
.
2.
Connect wheel hub. Refer to
.
BRC-32
[ABS]
ACTUATOR AND ELECTRIC UNIT
ACTUATOR AND ELECTRIC UNIT
PFP:47660
Removal and Installation
EFS002WK
SFIA0425E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст