Nissan Primera P12. Instruction — part 644
MT-18
[RS6F93R]
TRANSAXLE ASSEMBLY
CASE COMPONENTS
1.
Mechanism housing
2.
Gearbox edge bolt [63 N·m
(6.4 kg-m, 46 ft-lb)] and [52 N·m
(5.3 kg-m, 38 ft-lb)]
3.
Oil funnel
4.
Reverse gear switch [3 N·m
(0.3 kg-m, 27 in-lb)]
5.
Breather tube
6.
Differential joint
7.
Blanking cover
8.
Drain plug [3.5 N·m (0.36 kg-m,
31 in-lb)]
9.
Blanking cover
10. Fuel filler cap [3.5 N·m (0.36 kg-m,
31 in-lb)]
YMT046
TRANSAXLE ASSEMBLY
MT-19
[RS6F93R]
D
E
F
G
H
I
J
K
L
M
A
B
MT
CLUTCH HOUSING
Disassembly and Assembly
XXXX0000018
DISASSEMBLY
1.
Mount the B. Vi. 1417 on a support. With B. Vi. 1417 horizontal,
position the gearbox with the engine side against the plate. Fit
the gearbox on the B. Vi. 1417 support.
1.
Clutch housing
2.
Centring ring
3.
Hydraulic stop [2.1 N·m (0.21 kg-m,
19 in-lb)]
4.
Differential joint
5.
Sheath stop [2.1 N·m (0.21 kg-m,
19 in-lb)]
6.
Asbestos
7.
Input shaft seal
YMT045
YMT048
MT-20
[RS6F93R]
TRANSAXLE ASSEMBLY
2.
Remove the mounting bolts of the clutch slave cylinder, then
remove it.
3.
Remove the selection stop rod (A), the selection balls (B), the
two position sensors (C) and the selection control unit (D).
4.
Remove the selector fork shaft balls (E), the blanking cover (F)
and the gearbox edge bolts.
5.
Remove the retaining circlips from the secondary shaft bearings.
Then remove the mechanism housing.
YMT052
YMT053
YMT054
YMT055
TRANSAXLE ASSEMBLY
MT-21
[RS6F93R]
D
E
F
G
H
I
J
K
L
M
A
B
MT
6.
Remove the selection shaft balls (G) (see balls page), the switch
(H) and the reverse gear control rod and shaft (I). Recover the
two lock balls (or shaft) (see balls page).
7.
Unpin the fifth-sixth fork with B. Vi. 949. Unclip the fifth-sixth
control rod (J) and remove the shaft-fork unit. Recover the small
tappet in the fifth-sixth shaft and the two lock balls (see balls
page).
8.
Unclip the third-fourth fork (K). Unpin the third-fourth control rod
with B. Vi. 949.
Remove the third-forth shaft and fork unit. Recover the small
tappet inside the third-fourth shaft (see balls page).
9.
Unpin the first-second fork. Remove the first-second shaft and
fork unit, the reverse gear shaft and fork unit.
YMT056
YMT047
YMT057
YMT058
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст