Nissan Primera P12. Instruction — part 472
EX-2
EXHAUST SYSTEM
EXHAUST SYSTEM
PFP:20100
Checking Exhaust System
EBS00SIH
Check exhaust pipes, muffler and mounting for improper attachment,
leaks, cracks, damage or deterioration.
Removal and Installation
EBS00SII
CAUTION:
●
Be sure to use genuine exhaust system parts or equivalents which are specially designed for heat
resistance, corrosion resistance, and shape.
●
Perform the operation with the exhaust system fully cooled down because the system will be hot
just after the engine stops.
●
Be careful not to cut your hand on the insulator edge.
F9Q EMGINE MODELS
REMOVAL
●
Disconnect each joint and mounting.
SMA211A
MBIB0856E
1.
Mounting rubber
2.
Main muffler
3.
Ring gasket
4.
Exhaust front tube
5.
Exhaust center tube
EXHAUST SYSTEM
EX-3
C
D
E
F
G
H
I
J
K
L
M
A
EX
INSTALLATION
●
Install in the reverse order of removal.
CAUTION:
●
Always replace exhaust gaskets with new ones when reassembling.
●
If the insulator is badly deformed, repair or replace it. If deposits such as mud pile up on the insu-
lator, remove them.
●
When installing the insulator avoid large gaps or interference between the insulator and each
exhaust pipe.
●
Remove deposits from the sealing surface of each connection. Connect them securely to avoid
gas leakage.
●
Temporarily tighten mounting nuts on the exhaust manifold side and mounting bolts on the vehi-
cle side. Check each part for unusual interference, and then tighten them to the specified torque.
●
When installing each mounting rubber, avoid twisting or unusual extension in up/down and right/
left directions.
Inspection After Installation
EBS00SIJ
●
With the engine running, check exhaust tube joints for gas leakage and unusual noises.
●
Check to ensure that mounting brackets and mounting insulators are installed properly and free from
undue stress. Improper installation could result in excessive noise and vibration.
EX-4
EXHAUST SYSTEM
FAX-1
FRONT AXLE
D DRIVELINE/AXLE
CONTENTS
C
E
F
G
H
I
J
K
L
M
SECTION
A
B
FAX
FRONT AXLE
PRECAUTIONS . . . . . . . . . . . . . . .. 2
Caution . . . . . . . . . . . . . . . . . . 2
Precautions for Brake System . . . . . . . . .. 2
PREPARATION . . . . . . . . . . . . . . ... 3
Special Service Tools . . . . . . . . . . . ... 3
Commercial Service Tools . . . . . . . . . . 5
NOISE, VIBRATION AND HARSHNESS (NVH)
TROUBLESHOOTING . . . . . . . . . . . . 6
NVH Troubleshooting Chart . . . . . . . . . . 6
FRONT WHEEL HUB AND KNUCKLE . . . . . .. 7
On-Vehicle Inspection . . . . . . . . . . . .. 7
FRONT WHEEL BEARINGS . . . . . . . . 7
Removal and Installation . . . . . . . . . . .. 7
REMOVAL . . . . . . . . . . . . . . . . 7
INSTALLATION . . . . . . . . . . . . . . 8
Disassembly and Assembly . . . . . . . . . .. 8
DISASSEMBLY . . . . . . . . . . . . . . 8
INSPECTION AFTER DISASSEMBLY . . . . .. 9
ASSEMBLY . . . . . . . . . . . . . . ... 9
FRONT DRIVE SHAFT . . . . . . . . . . . . 11
Removal and Installation . . . . . . . . . . 11
REMOVAL . . . . . . . . . . . . . . ... 11
INSPECTION AFTER REMOVAL . . . . . ... 12
INSTALLATION . . . . . . . . . . . . ... 13
Disassembly and Assembly . . . . . . . . . 14
DISASSEMBLY . . . . . . . . . . . . ... 14
INSPECTION AFTER DISASSEMBLY . . . . 17
ASSEMBLY . . . . . . . . . . . . . . . 17
SERVICE DATA AND SPECIFICATIONS (SDS) . .. 23
Wheel Bearing . . . . . . . . . . . . . . 23
Drive Shaft . . . . . . . . . . . . . . . .. 23
Dynamic Damper . . . . . . . . . . . . . 24
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст