Nissan Primera P12. Instruction — part 581

LT-34

HEADLAMP (WITH DAYTIME) - XENON TYPE -

Bulb Replacement

EKS009MA

Refer to

LT-16, "Bulb Replacement"

.

Aiming Adjustment

EKS009MB

Refer to

LT-15, "Aiming Adjustment"

.

LH low beam does not operate (with day-
time operation) but LH low beam operates
(with lighting switch 2nd position).

1. 15A fuse

2. Daytime light circuit

3. Daytime light control unit

1. Check 15A fuse (No. 41, located in fuse

and fusible link box).
Verify battery positive voltage is present
at terminal 2 (R/W) of daytime light con-
trol unit.

2. Check continuity between daytime light

control unit terminal 5 (R/Y) and
headlamp LH terminal 5 (R/Y).

3. Check daytime light unit. Refer to

LT-24

.

RH low beam does not operate (with day-
time operation) but RH low beam operates
(with lighting switch 2nd position).

1. 15A fuse

2. Daytime light circuit

3. Daytime light control unit

1. Check 15A fuse (No. 42, located in fuse

and fusible link box).
Verify battery positive voltage is present
at terminal 3 (R) of daytime light control
unit.

2. Check continuity between daytime light

control unit terminal 4 (R/L) and
headlamp RH terminal 5 (R/L).

3. Check daytime light unit. Refer to

LT-24

.

Symptom

Possible cause

Repair order

HEADLAMP AIMING CONTROL (MANUAL)

LT-35

C

D

E

F

G

H

I

J

L

M

A

B

LT

HEADLAMP AIMING CONTROL (MANUAL)

PFP:25190

Wiring Diagram — H/AIM —

EKS009MC

MKWA1098E

LT-36

HEADLAMP AIMING CONTROL (MANUAL)

Removal and Installation

EKS009MD

1.

Remove the Instrument lower driver panel. Refer to IP section in
P12 ESM (SM2E00-1P12E0E) .

2.

Press the headlamp aiming switch fixing tabs and remove the
unit from the instrument lower driver panel.

Switch Circuit Inspection

EKS009ME

Using a circuit tester, check continuity between the headlamp aiming switch connector terminals in each oper-
ation status of the aiming switch.

MKIB0119E

HEADLAMP AIMING CONTROL (AUTO)

LT-37

C

D

E

F

G

H

I

J

L

M

A

B

LT

HEADLAMP AIMING CONTROL (AUTO)

PFP:53821

System Description

EKS009MF

The height sensor is designed to adjust the beam angle of the headlamp in response to the loading conditions
of the vehicle and vehicle speed. It is not designed to compensate for the dynamic handling of the vehicle.
The vehicle rear height is measured by height sensor attached to the rear suspension lateral link arm. Height
sensor receives vehicle speed signal from combination meter. The height sensor calculates the correct
headlamp aiming position and sends a signal to the aiming motors.

Component Parts and Harness

EKS009MG

CONNECTOR LOCATION

MKIB0258E