Nissan Primera P12. Instruction — part 63
NAVIGATION SYSTEM
AV-95
C
D
E
F
G
H
I
J
L
M
A
B
AV
Rear Defogger Indicator Lamp Does Not Illuminate
EKS009KA
1.
CHECK POSITION OF IGNITION SWITCH
Is ignition switch ON?
OK or NG
OK
>> GO TO 2.
NG
>> Rear defogger does not operate if ignition switch is not ON.
2.
CHECK OPERATION OF REAR DEFOGGER
Does rear defogger operate when rear defogger switch is turned ON? (Does fogging disappear?)
Yes or No
Yes
>> GO TO 3.
No
>> Check rear defogger system. Refer to
AV-94, "Rear Defogger Does Not Operate"
.
3.
CHECK REAR DEFOGGER INDICATOR LAMP SIGNALS
1.
Turn ignition switch OFF.
2.
Disconnect multifunction switch connector.
3.
Check voltage between multifunction switch connector M49 ter-
minal 10 (L/R) and ground.
OK or NG
OK
>> Replace multifunction switch.
NG
>> Check harness for open or short between multifunction
switch and rear defogger relay.
No Fuel Information Is Displayed/No Warning Message Is Displayed
EKS009KB
1.
CHECK DISPLAY CONDITIONS
Check display conditions for all warning screens.
>> GO TO 2.
Battery voltage should exist.
SKIA1433E
Display Items
Display condition
Parking brake drag, door ajar
PKB switch or any door switch is ON and vehicle speed is approximately 5 km/h
(3MPH) or higher.
Remaining fuel
After driving approximately 20 km (13MPH) beyond the point where gauge warning
lamp illuminates.
Other than above
Gauge warning lamp illuminated.
AV-96
NAVIGATION SYSTEM
2.
HARNESS CHECK
1.
Turn the ignition switch OFF.
2.
Disconnect connectors of combination meter and AV and NAVI control unit.
3.
Check continuity between AV and NAVI control unit and combination meter.
4.
Check continuity between AV and NAVI control unit and ground.
OK or NG
OK
>> GO TO 3.
NG
>>
●
Repair harness.
●
Check connector housings for disconnected or loose terminals.
3.
COMMUNICATION SIGNAL (AV–ME) CHECK
1.
Connect connectors of combination meter and AV and NAVI control unit.
2.
Turn the ignition switch ON.
3.
Check voltage signal between AV and NAVI control unit terminal 34 and ground.
OK or NG
OK
>> GO TO 4.
NG
>> Replace AV and NAVI control unit.
4.
COMMUNICATION SIGNAL (ME–AV) CHECK
1.
Turn ignition switch to ON and display “VEHICLE ELECTRONIC SYSTEMS” screen.
2.
Check voltage signal between AV and NAVI control unit harness
connector M55 terminal 35 (G) and ground.
OK or NG
OK
>> Replace AV and NAVI control unit.
NG
>> Check combination meter system.
for LHD models or
bination Meter Self-Diagnosis"
for RHD models.
Terminals
Continuity
(+)
(-)
Connector
Terminal (wire color)
Connector
Terminal (wire color)
M55
34 (R)
M37
LHD
41 (R)
Yes
RHD
28(R)
35 (G)
LHD
40 (G)
Yes
RHD
27(G)
Terminals
Continuity
(+)
(-)
Connector
Terminal (wire color)
M55
34 (R), 35 (G)
Ground
No
MKIB0654E
Terminals
Voltage (V)
(+)
(-)
Connector
Terminal (wire color)
M55
34 (R)
Ground
MKIB0655E
35 (G)- ground
:
Reference Value for AV
and NAVI Control Unit"
MKIB0656E
NAVIGATION SYSTEM
AV-97
C
D
E
F
G
H
I
J
L
M
A
B
AV
Previous Conditions Are Not Stored
EKS009KC
1.
BATTERY POWER CHECK
●
Check AV and NAVI control unit battery power.
Refer to
AV-80, "Power Supply and Ground Circuit Check"
.
OK or NG
OK
>> Replace AV and NAVI control unit.
NG
>> Check AV and NAVI control unit battery power system harness.
The Position of The Current-Location Mark Is Not Correct
EKS009KD
1.
SELF-DIAGNOSIS
●
“Self-diagnosis mode” of the self-diagnosis function
.
OK or NG
OK
>> GO TO 2.
NG
>> Check the applicable parts.
2.
HISTORY OF ERRORS DIAGNOSIS
●
Was any error stored in
of the CONFIRMATION/ADJUSTMENT mode?
Yes or No
Yes
>>
AV-77, "DIAGNOSIS BY HISTORY OF ERRORS"
No
>>
Radio Wave From The GPS Satellite Is Not Received
EKS009KE
1.
ENVIRONMENT CHECK
●
Check if any metal object that intercepts radio waves or an object that emits radio waves (such as a porta-
ble phone) is located near the GPS antenna. Check if the vehicle is shielded by a building.
OK or NG
OK
>>
●
System is normal.
The GPS antenna may not be able to receive radio waves from the GPS satellite if it is shielded
by metal object or an object emitting radio waves is placed near it.
NG
>> GO TO 2.
2.
SELF-DIAGNOSIS
●
Refer to
.
OK or NG
OK
>> Replace GPS antenna.
NG
>> Check the applicable parts.
Display Does Not Change When Screen Adjustment Is Performed
EKS009KF
1.
CHECK SYMPTOM
Do other systems operate properly?
Do operate.>>Replace the display.
Do not operate.>>Check the problem again.
AV-98
NAVIGATION SYSTEM
Day/Night Display Switching Is Not Done. Night Illumination for AV and NAVI
Control Unit Does Not Illuminate
EKS009KG
1.
VEHICLE SIGNAL CHECK
1.
Start the engine.
2.
Diagnose the following items with
in CONFIRMATION/ADJUSTMENT
mode.
OK or NG
OK
>> Replace AV and NAVI control unit.
NG
>>
AV-83, "Illumination Control Signal Check"
.
On Multifunction Switch, a Specific Switch Does Not Operate in All Conditions
EKS009KH
●
Replace multifunction switch.
Driving Information Is Inaccurate. Maintenance Information Is Inaccurate
EKS009KI
1.
VEHICLE SPEED SIGNAL INSPECTION
Check vehicle speed signal.
AV-82, "Vehicle Speed Signal Check"
.
OK or NG
OK
>> Replace AV and NAVI control unit.
NG
>> Check combination meter system.
DI-14, "Combination Meter Self-Diagnosis"
for LHD models or
DI-37, "Combination Meter Self-Diagnosis"
for RHD models.
System Does Not Start
EKS009KJ
1.
INSPECT POWER SYSTEM
Inspect power system of AV and NAVI control unit.
AV-80, "Power Supply and Ground Circuit Check"
.
OK or NG
OK
>> Replace AV and NAVI control unit.
NG
>> Malfunction in power system of AV and NAVI control unit
The Current Position Mark Is in the Wrong Place
EKS009KK
1.
CHECK SYMPTOM
●
AV-101, "Example of Symptoms Judged Not Abnormal"
Yes or No
Yes
>> The limit of the navigation location detection capability has been reached.
No
>> GO TO 2.
2.
SELF-DIAGNOSIS
●
Perform
.
OK or NG
OK
>> GO TO 3.
NG
>> Check the applicable parts.
<Lamp signals>
Lighting switch position 1
: ON
Lighting switch OFF
: OFF
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст