Nissan Primera P12. Instruction — part 456
EM-170
[F9Q]
OVERHAUL
3.
Remove the front timing belt cover.
NOTE:
Use a pencil to mark the lower timing housing opposite the mark
on the camshaft pulley.
4.
Remove the crankshaft pulley by using Tool KV113B0060 (Mot.
582-01) or KV113B0410 (Mot. 1677).
5.
Relax the tensioner by loosening the nut (3), then remove the
timing belt.
MBIB0716E
MBIB0717E
MBIB0718E
OVERHAUL
EM-171
[F9Q]
C
D
E
F
G
H
I
J
K
L
M
A
EM
6.
Remove the camshaft position sensor.
7.
Remove the cylinder head bolts in the reverse order as shown,
then remove the cylinder head.
CYLINDER HEAD
1.
Place the cylinder head on Tool KV113B0200 (Mot. 1573).
●
Pay strict attention to the instructions regarding cleanliness.
Refer to
.
2.
Remove the fuel return pipe.
●
Install the cleanliness blanking plates on the high-pressure
pump and the injector.
MBIB0719E
MBIB0668E
MBIB0720E
MBIB0722E
EM-172
[F9Q]
OVERHAUL
3.
Remove the high-pressure fuel pipes using Tool KV113E0010
(Mot. 1566).
●
Install the cleanliness blanking plates on the high-pressure
pump and the injectors.
4.
Remove the two common rail bolt (1).
5.
Remove the injector mounting bracket bolt (2).
6.
Remove the injector, installing cleanliness blanking plate on the
injector nose.
7.
Remove flame arrestor washer.
8.
Remove the rear high-pressure pump support bolt.
9.
Remove the cylinder head suspended mounting support bolt.
10. Remove high-pressure pump and cylinder head suspended
assembly from cylinder head.
●
If separate cylinder head suspended mounting and high-pres-
sure pump, refer to EC-xx, “
” (F9Q).
11. Remove the camshaft pulley bolt by blocking the pulley using
Tool KV113B0070 (Mot. 799-01).
MBIB0723E
MBIB0724E
MBIB0985E
MBIB0982E
MBIB0729E
OVERHAUL
EM-173
[F9Q]
C
D
E
F
G
H
I
J
K
L
M
A
EM
12. Remove the rear timing belt cover.
13. Remove the rear engine slinger.
14. Remove the glow plug using a 10 mm (0.39 in) articulated
wrench.
15. Remove the vacuum pump.
16. Remove the water outlet.
17. Remove the rocker cover bolts in the reverse order as shown.
18. Remove the camshaft bearing beam bolts in the reverse order
as shown.
MBIB0730E
MBIB0731E
MBIB0732E
MBIB0744E
MBIB0743E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст