Nissan Versa Sedan. Instruction — part 597
MWI
METER SYSTEM
MWI-87
< WIRING DIAGRAM >
[TYPE B]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
ABNIA4549GB
MWI-88
< BASIC INSPECTION >
[TYPE B]
DIAGNOSIS AND REPAIR WORKFLOW
BASIC INSPECTION
DIAGNOSIS AND REPAIR WORKFLOW
Work Flow
INFOID:0000000009266523
OVERALL SEQUENCE
DETAILED FLOW
1.
CONFIRM SYMPTOM
Confirm symptom or customer complaint.
>> GO TO 2
2.
SELF-DIAGNOSIS OF COMBINATION METER
Perform self-diagnosis of combination meter. Refer to
MWI-68, "Diagnosis Description"
.
Is the inspection result normal?
YES
>> GO TO 3
NO
>> If self-diagnosis will not start, check power supply and ground circuit of combination meter. Refer
to
MWI-94, "COMBINATION METER : Diagnosis Procedure"
. If power supply and ground circuits
are OK, replace combination meter. Refer to
MWI-104, "Removal and Installation"
.
3.
CHECK COMBINATION METER WITH CONSULT
Select “METER/M&A” on CONSULT and perform self-diagnosis of combination meter. Refer to
Is the inspection result normal?
YES
>> Check symptom. GO TO 4.
NO
>> Refer to
.
4.
CHECK SYSTEM OPERATION
Check the combination meter to verify that the repair has been completed successfully.
Is the inspection result normal?
YES
>> Inspection End.
NO
>> GO TO 1
AWNIA2458GB
MWI
U1000 CAN COMM CIRCUIT
MWI-89
< DTC/CIRCUIT DIAGNOSIS >
[TYPE B]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
DTC/CIRCUIT DIAGNOSIS
U1000 CAN COMM CIRCUIT
DTC Logic
INFOID:0000000009266524
DTC DETECTION LOGIC
Diagnosis Procedure
INFOID:0000000009266525
1.
CHECK DTC DETECTION
With CONSULT.
1. Turn ignition switch OFF to ON.
2. Perform self diagnostic result.
Is DTC U1000 detected?
YES
>> Proceed to diagnosis procedure. Refer to
LAN-15, "Trouble Diagnosis Flow Chart"
.
NO
>> Refer to
GI-45, "Intermittent Incident"
.
DTC
Display Item
Malfunction detected condition
Possible causes
U1000
CAN COMM CIRCUIT
When CAN communication signal is not continuously
received for 2 seconds or more
CAN communication system mal-
function
MWI-90
< DTC/CIRCUIT DIAGNOSIS >
[TYPE B]
U1010 CONTROL UNIT (CAN)
U1010 CONTROL UNIT (CAN)
Description
INFOID:0000000009266526
Initial diagnosis of combination meter.
DTC Logic
INFOID:0000000009266527
DTC DETECTION LOGIC
Diagnosis Procedure
INFOID:0000000009266528
1.
REPLACE COMBINATION METER
Replace combination meter. Refer to
MWI-104, "Removal and Installation"
>> Inspection End.
DTC
CONSULT
Description
Probable malfunction location
U1010
CONTROL UNIT (CAN)
Error detected during the initial diagnosis of the
CAN controller of combination meter.
Combination meter
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст