Nissan Versa Sedan. Instruction — part 665
RSU-10
< REMOVAL AND INSTALLATION >
REAR SHOCK ABSORBER
CAUTION:
Dispose of drained oil according to the law and local regulations.
COIL SPRING
RSU-11
< REMOVAL AND INSTALLATION >
C
D
F
G
H
I
J
K
L
M
A
B
RSU
N
O
P
COIL SPRING
Exploded View
INFOID:0000000009267422
Removal and Installation
INFOID:0000000009267423
REMOVAL
1. Remove the wheel and tire assemblies using power tool. Refer to
2. Position a suitable jack under rear suspension beam.
CAUTION:
• Place the jack in the center of the suspension beam.
• Do not damage the suspension beam with jack.
3. Remove the lower shock absorber bolts. Refer to
RSU-8, "Removal and Installation"
.
4. Slowly lower jack, then remove upper rubber seat, coil spring and lower rubber seat from rear suspension
beam.
INSTALLATION
Installation is in the reverse order of removal.
• Install the lower rubber seat (A) to the rear suspension beam
mounting hole (B).
• Match up lower rubber seat indentions and rear suspension beam
grooves and attach.
Inspection
INFOID:0000000009267424
INSPECTION AFTER REMOVAL
Check rubber seat and coil spring for deformation, crack, and damage. Replace it if necessary.
INSPECTION AFTER INSTALLATION
1.
Upper rubber seat
2.
Coil spring
3.
Lower rubber seat
4.
Rear suspension beam
JPEIB0162ZZ
JPEIB0223ZZ
RSU-12
< REMOVAL AND INSTALLATION >
COIL SPRING
Check wheel alignment. Refer to
.
REAR SUSPENSION BEAM
RSU-13
< REMOVAL AND INSTALLATION >
C
D
F
G
H
I
J
K
L
M
A
B
RSU
N
O
P
REAR SUSPENSION BEAM
Exploded View
INFOID:0000000009267425
Removal and Installation
INFOID:0000000009267426
REMOVAL
1. Remove the wheel and tire assemblies using power tool. Refer to
2. Remove wheel sensor and sensor harness. Refer to
BRC-105, "REAR WHEEL SENSOR : Removal and
.
3. Remove brake hose and brake pipe from rear suspension beam. Refer to
.
4. Remove the rear drum brake assemblies. Refer to
BR-41, "Removal and Installation"
.
5. Remove parking brake cable from rear suspension beam. Refer to
PB-6, "Removal and Installation"
.
6. Position a suitable jack under rear suspension beam.
CAUTION:
• Place the jack in the center of the suspension beam.
• Do not damage the suspension beam with jack.
7. Remove shock absorber bolts (lower side). Refer to
RSU-8, "Removal and Installation"
8. Remove coil spring. Refer to
RSU-11, "Removal and Installation"
9. Remove rear suspension beam bolts and nuts.
10. Slowly lower jack, remove rear suspension beam from vehicle body.
CAUTION:
While lowering the rear suspension beam with the jack, be sure to maintain the stability of the
jack.
INSTALLATION
Installation is in the reverse order of removal.
• Perform final tightening of rear suspension beam installation position (rubber bushing), under unladen condi-
tions with tires on level ground.
• Check wheel sensor harness for proper connection. Refer to
.
• Adjust parking brake. Refer to
PB-4, "Inspection and Adjustment"
• Check wheel alignment. Refer to
1.
Rear suspension beam
JPEIB0254GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст