Nissan Versa Sedan. Instruction — part 132
BRM-10
< PREPARATION >
REPAIRING MATERIAL
PREPARATION
REPAIRING MATERIAL
Foam Repair
INFOID:0000000009268576
During factory assembly, foam insulators are installed in certain body panels and locations around the vehicle.
Use the following procedure(s) to replace any factory-installed foam insulators.
URETHANE FOAM APPLICATIONS
Use commercially available Urethane foam for sealant (foam material) repair of material used on vehicle.
Read instructions on product for fill procedures.
FILL PROCEDURES
Example of foaming agent filling operation procedure:
1. Fill procedures after installation of service part.
a. Eliminate foam material remaining on vehicle side.
b. Clean area after eliminating form insulator and foam material.
c.
Install service part.
d. Insert nozzle into hole (A) near fill area and fill foam material (1) or fill enough to close gap with the service
part.
2. Fill procedures before installation of service part:
a. Eliminate foam material remaining on vehicle side.
b. Clean area after eliminating foam insulator and foam material.
c.
Fill with enough foam material on the wheelhouse outer side to close the gap with the service part while
avoiding the flange area.
<Urethane foam for foaming agent>
3M™ Automix™ Flexible Foam 08463 or equiva-
lent
1.
Urethane foam
A. Nozzle insert hole
Front
JSKIA0129GB
REPAIRING MATERIAL
BRM-11
< PREPARATION >
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
d. Install service part.
NOTE:
Refer to the label on the urethane foam container for information
on working times.
1.
Urethane foam
A.
Fill while avoiding flange area
: Front
JSKIA0130GB
ALKIA2576GB
BRM-12
< PREPARATION >
REPAIRING MATERIAL
1.
Body side outer
2.
Body side insulation (foam) front pil-
lar
3.
Body side insulation (foam) roof side
rail
4.
Roof panel assembly
5.
Body side insulation (foam) rear pil-
lar
6.
Body side insulation (foam) rear pil-
lar lower
7.
Body side insulation strip, front pillar
lower reinforcement
Front
BODY COMPONENT PARTS
BRM-13
< PREPARATION >
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
BODY COMPONENT PARTS
Underbody Component Parts
INFOID:0000000009268577
1.
Front floor center
2.
Front floor assembly (LH/RH)
3.
Sill reinforcement (LH/RH)
4.
Dash side (LH/RH)
5.
Upper dash assembly
6.
Member dash lower cross
7.
Lower dash assembly
8.
Strut housing (LH/RH)
9.
Hood ledge (LH/RH)
ALKIA2662ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст