Nissan Altima L32. Instruction — part 1361
SEC-594
< SYMPTOM DIAGNOSIS >
[SEDAN WITHOUT INTELLIGENT KEY]
VEHICLE SECURITY SYSTEM SYMPTOMS
VEHICLE SECURITY SYSTEM SYMPTOMS
Symptom Table
INFOID:0000000004499245
*: Check that the system is in the armed phase.
Procedure
Diagnostic procedure
Refer to page
Symptom
1
Vehicle security sys-
tem cannot be set by
····
Door switch
Check door switch
Trunk
Check trunk room lamp switch
Door outside key
Check key cylinder switch
Keyfob
Check keyfob.
—
Check Intermittent Incident
Security indicator does not turn ON.
Check vehicle security indicator
Check Intermittent Incident
2
* Vehicle security
system does not
sound alarm when ····
Any door is opened.
Check door switch
Check Intermittent Incident
3
Vehicle security
alarm does not acti-
vate.
Horn alarm
Check horn
Check Intermittent Incident
Head lamp alarm
Check head lamp alarm
Check Intermittent Incident
4
Vehicle security sys-
tem cannot be can-
celed by ····
Door outside key
Check key cylinder switch
Check Intermittent Incident
Keyfob
Check keyfob
Check Intermittent Incident
NISSAN VEHICLE IMMOBILIZER SYSTEM-NATS SYMPTOMS
SEC-595
< SYMPTOM DIAGNOSIS >
[SEDAN WITHOUT INTELLIGENT KEY]
C
D
E
F
G
H
I
J
L
M
A
B
SEC
N
O
P
NISSAN VEHICLE IMMOBILIZER SYSTEM-NATS SYMPTOMS
Symptom Table
INFOID:0000000004499246
Security indicator does not turn ON or flash.
CAUTION:
• Follow Trouble Diagnosis Flowchart referring to “
”. Determine malfunctioning
condition before performing this diagnosis.
• Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagno-
sis.
• Check systems shown in the “Action” column in this order.
CONDITIONS OF VEHICLE (OPERATING CONDITIONS)
• Keyfob is not inserted into key slot.
• Engine switch is not depressed.
Action
Reference page
1. Check vehicle security indicator
2. Check Intermittent Incident
SEC-596
< ON-VEHICLE REPAIR >
[SEDAN WITHOUT INTELLIGENT KEY]
KEY SLOT
ON-VEHICLE REPAIR
KEY SLOT
Removal and Installation
INFOID:0000000004499249
REMOVAL
1. Remove the instrument lower panel LH. Refer to
IP-12, "Removal and Installation"
.
2. Disconnect key slot connector.
3. Remove the key slot screw (A), and then remove key slot (1)
from instrument lower panel LH (2).
INSTALLATION
Installation is in the reverse order of removal.
AWKIA1495ZZ
PUSH BUTTON IGNITION SWITCH
SEC-597
< ON-VEHICLE REPAIR >
[SEDAN WITHOUT INTELLIGENT KEY]
C
D
E
F
G
H
I
J
L
M
A
B
SEC
N
O
P
PUSH BUTTON IGNITION SWITCH
Removal and Installation
INFOID:0000000004499250
REMOVAL
1. Remove the cluster lid A assembly. Refer to
IP-12, "Removal and Installation"
2. Release the pawls (A) and remove the push-button ignition
switch (1) from cluster lid A.
INSTALLATION
Installation is in the reverse order of removal.
JMKIA0167ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст