Nissan Altima L32. Instruction — part 744
EXL-260
< ON-VEHICLE REPAIR >
REAR COMBINATION LAMP
REAR COMBINATION LAMP
Bulb Replacement
INFOID:0000000004201566
REAR TURN SIGNAL LAMP
Removal
1. Remove the rear combination lamp. Refer to
EXL-260, "Removal and Installation"
2. Turn the rear turn signal lamp bulb socket counterclockwise and remove it.
3. Remove the rear turn signal lamp bulb.
Installation
Installation is in the reverse order of removal.
STOP/TAIL LAMP
Removal
1. Remove the rear combination lamp. Refer to
EXL-260, "Removal and Installation"
2. Turn the stop/tail lamp bulb socket counterclockwise and remove it.
3. Remove the stop/tail lamp bulb.
Installation
Installation is in the reverse order of removal.
BACK-UP LAMP
Removal
1. Remove the rear combination lamp. Refer to
EXL-260, "Removal and Installation"
2. Turn the back-up lamp bulb socket counterclockwise and remove it.
3. Remove the back-up lamp bulb.
Installation
Installation is in the reverse order of removal.
SIDE MARKER LAMP
Removal
1. Remove the rear combination lamp. Refer to
EXL-260, "Removal and Installation"
2. Turn the side marker lamp bulb socket counterclockwise and remove it.
3. Remove the side marker lamp bulb.
Installation
Installation is in the reverse order of removal.
Removal and Installation
INFOID:0000000004201567
COMPONENTS
REAR COMBINATION LAMP
EXL-261
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
REMOVAL
1. Remove trunk side finisher. Refer to
INT-23, "Removal and Installation"
2. Remove the rear combination lamp nuts.
3. Pull the rear combination lamp assembly toward rear of the vehicle and remove.
INSTALLATION
Installation is the reverse order of removal.
1.
Rear combination lamp assembly
2.
Back-up lamp bulb
3.
Stop/Tail lamp bulb
4.
Rear combination lamp harness
5.
Side marker lamp bulb
6.
Rear turn signal lamp bulb
ALLIA0039ZZ
EXL-262
< ON-VEHICLE REPAIR >
LIGHTING AND TURN SIGNAL SWITCH
LIGHTING AND TURN SIGNAL SWITCH
Removal and Installation
INFOID:0000000004201568
Removal
1. Remove the spiral cable. Refer to
SR-8, "Removal and Installation"
2. Disconnect the lighting and turn signal switch connector and remove the lighting and turn signal switch.
Installation
Installation is in the reverse order of removal.
HAZARD SWITCH
EXL-263
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
HAZARD SWITCH
Removal and Installation
INFOID:0000000004201569
Removal
1. Remove the cluster lid C. Refer to
IP-12, "Removal and Installation"
2. Remove CVT finisher or M/T finisher. Refer to
TM-255, "Removal and Installation"
3. Remove the hazard switch screws (A) and remove the hazard
switch. (1).
Installation
Installation is in the reverse order of removal.
ALLIA0037ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст