Nissan Altima L32. Instruction — part 161
BRM-34
< ON-VEHICLE REPAIR >
[COUPE]
REPLACEMENT OPERATIONS
The symbols used in this section for cutting and welding / brazing operations are shown below.
PIIA0149E
REPLACEMENT OPERATIONS
BRM-35
< ON-VEHICLE REPAIR >
[COUPE]
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
• Front pillar butt joint can be determined anywhere within shaded
area as shown in the figure. The best location for the butt joint is at
position A due to the construction of the vehicle. Refer to the front
pillar section.
• Determine cutting position and record distance from the locating
indent. Use this distance when cutting the service part. Cut outer
front pillar over 60 mm above inner front pillar cut position.
• Prepare a cutting jig to make outer pillar easier to cut. Also, this will
permit service part to be accurately cut at joint position.
• An example of cutting operation using a cutting jig is as follows.
1. Mark cutting lines.
A: Cut position of outer pillar
B: Cut position of inner pillar
2. Align cutting line with notch on jig. Clamp jig to pillar.
3. Cut outer pillar along groove of jig. (At position A)
4. Remove jig and cut remaining portions.
5. Cut inner pillar at position B in same manner.
PIIA0150E
PIIA0151E
PIIA0152E
PIIA0153E
BRM-36
< ON-VEHICLE REPAIR >
[COUPE]
REPLACEMENT OPERATIONS
Hoodledge
INFOID:0000000004205863
Front Side Member Front Assembly
INFOID:0000000004205864
• Work after the hoodledge has been removed.
ALKIA0719GB
Change parts
z
Front strut housing (LH)
z
Upper front hoodledge
z
Hoodledge reinforcement
z
Hoodledge connector
z
Radiator core support upper
z
Hoodledge reinforcement rear
REPLACEMENT OPERATIONS
BRM-37
< ON-VEHICLE REPAIR >
[COUPE]
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
Change parts
z
Front side member front assembly
z
Front side member front closing plate
z
Radiator core side support
ALKIA0720GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст