Nissan Altima L32. Instruction — part 173
BRM-82
< ON-VEHICLE REPAIR >
[SEDAN]
PRECAUTIONS IN REPAIRING HIGH STRENGTH STEEL
• When welding HSS panels, use spot welding whenever possi-
ble in order to minimize weakening surrounding areas due to
heat.
If spot welding is impossible, use M.I.G. welding. Do not use
gas (torch) welding because it is inferior in welding strength.
• The spot weld on HSS panels is harder than that of an ordi-
nary steel panel.
Therefore, when cutting spot welds on a HSS panel, use a low
speed high torque drill (1,000 to 1,200 rpm) to increase drill bit
durability and facilitate the operation.
2. Precautions in spot welding HSS
This work should be performed under standard working condi-
tions. Always note the following when spot welding HSS:
• The electrode tip diameter must be sized properly according to
the metal thickness.
• The panel surfaces must fit flush to each other, leaving no
gaps.
PIIA0144E
PIIA0145E
PIIA0146E
PIIA0147E
PRECAUTIONS IN REPAIRING HIGH STRENGTH STEEL
BRM-83
< ON-VEHICLE REPAIR >
[SEDAN]
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
• Follow the specifications for the proper welding pitch.
Unit:mm
Thickness (t)
Minimum pitch (l)
0.6 (0.024)
0.8 (0.031)
1.0 (0.039)
1.2 (0.047)
1.6 (0.063)
1.8 (0.071)
10 (0.39) or over
12 (0.47) or over
18 (0.71) or over
20 (0.79) or over
27 (1.06) or over
31 (1.22) or over
PIIA0148E
BRM-84
< ON-VEHICLE REPAIR >
[SEDAN]
REPLACEMENT OPERATIONS
REPLACEMENT OPERATIONS
Description
INFOID:0000000004205896
This section is prepared for technicians who have attained a high level of skill and experience in repairing col-
lision-damaged vehicles and also use modern service tools and equipment. Persons unfamiliar with body
repair techniques should not attempt to repair collision-damaged vehicles by using this section.
Technicians are also encouraged to read Body Repair Instruction (Fundamentals) in order to ensure that the orig-
inal functions and quality of the vehicle can be maintained. The Body Repair Instruction (Fundamentals) contains
additional information, including cautions and warning, that are not including in this instruction. Technicians
should refer to both instructions to ensure proper repairs.
Please note that these information are prepared for worldwide usage, and as such, certain procedures might
not apply in some regions or countries.
REPLACEMENT OPERATIONS
BRM-85
< ON-VEHICLE REPAIR >
[SEDAN]
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
The symbols used in this section for cutting and welding / brazing operations are shown below.
PIIA0149E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст