Nissan Pathfinder (2012 year). Instruction — part 77
AV-434
< REMOVAL AND INSTALLATION >
[BOSE AUDIO WITH NAVIGATION]
GPS ANTENNA
GPS ANTENNA
Removal and Installation
INFOID:0000000007347957
REMOVAL
1. Remove the cluster lid C. Refer to
IP-16, "Removal and Installation"
.
2. Remove the GPS antenna screws (A), detach the GPS antenna
harness clip (B).
3. Remove GPS antenna and feeder assembly (1) out of the instru-
ment panel.
INSTALLATION
Installation is in the reverse order of removal.
ALNIA0378ZZ
August 2012
2012 Pathfinder
AV
SATELLITE RADIO ANTENNA
AV-435
< REMOVAL AND INSTALLATION >
[BOSE AUDIO WITH NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
SATELLITE RADIO ANTENNA
Removal and Installation
INFOID:0000000007347958
REMOVAL
1. Remove the front roof console finisher. Refer to
INT-22, "Removal and Installation"
.
2. Disconnect the satellite antenna connector.
3. Remove the satellite antenna nut.
4. Remove the satellite antenna.
INSTALLATION
Installation is in the reverse order of removal.
LKIA0679E
August 2012
2012 Pathfinder
AV-436
< REMOVAL AND INSTALLATION >
[BOSE AUDIO WITH NAVIGATION]
STEERING SWITCH
STEERING SWITCH
Removal and Installation
INFOID:0000000007347959
REMOVAL
1. Remove the driver air bag module. Refer to
SR-5, "Removal and Installation"
2. Remove the steering wheel audio control switch assembly screws.
3. Disconnect the steering wheel audio control switches connector.
4. Remove the steering wheel audio control switches by pulling on
steering wheel audio control switches to release the pawls.
CAUTION:
Do not tilt steering wheel audio control switches during
removal or damage may occur to the pawls.
•
: Pawl
INSTALLATION
Installation is in the reverse order of removal.
1. Steering wheel
2.
Steering wheel audio control switches
ALNIA0357ZZ
ALNIA1214ZZ
August 2012
2012 Pathfinder
AV
MICROPHONE
AV-437
< REMOVAL AND INSTALLATION >
[BOSE AUDIO WITH NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
MICROPHONE
Removal and Installation
INFOID:0000000007347960
REMOVAL
1. Remove the front roof console finisher. Refer to
INT-22, "Removal and Installation"
.
2. Detach the microphone (1) from the front console finisher tabs
(A).
3. Disconnect the microphone connector (B) and remove the
microphone (1).
INSTALLATION
Installation is in the reverse order of removal.
ALNIA0379ZZ
August 2012
2012 Pathfinder
AV-438
< REMOVAL AND INSTALLATION >
[BOSE AUDIO WITH NAVIGATION]
REAR VIEW CAMERA
REAR VIEW CAMERA
Removal and Installation
INFOID:0000000007347961
REMOVAL
1. Remove the license lamp finisher. Refer to
EXT-23, "Removal and Installation"
.
2. Disconnect the rear view camera connector.
3. Detach the rear view camera harness clip.
4. Detach the rear view camera to release, then pull out to remove the rear view camera while feeding the
rear view camera harness and connector through the back door.
INSTALLATION
Installation is in the reverse order of removal.
1.
Rear view camera
A.
Rear view camera connector
B.
Rear view camera harness clip
ALNIA1182ZZ
August 2012
2012 Pathfinder
BCS
BCS-1
ELECTRICAL & POWER CONTROL
C
D
E
F
G
H
I
J
K
L
B
SECTION
BCS
A
O
P
N
CONTENTS
BODY CONTROL SYSTEM
BASIC INSPECTION . . . . . . . . .
INSPECTION AND ADJUSTMENT . . . . . .
ADDITIONAL SERVICE WHEN REPLACING
CONTROL UNIT (BCM) . . . . . . . . . . . ...
ADDITIONAL SERVICE WHEN REPLACING
CONTROL UNIT (BCM) : Description . . . . . ...
ADDITIONAL SERVICE WHEN REPLACING
CONTROL UNIT (BCM) : Work Procedure . . . ...
CONFIGURATION (BCM) . . . . . . . . . . ...
CONFIGURATION (BCM) : Description . . . . ....
CONFIGURATION (BCM) : Work Procedure . . ....
CONFIGURATION (BCM) : Configuration List . . ..
SYSTEM DESCRIPTION . . . . . . . ..
BODY CONTROL SYSTEM . . . . . . . .
System Description . . . . . . . . . . . . ...
Component Parts Location . . . . . . . . . ....
COMBINATION SWITCH READING SYSTEM
. .
System Diagram . . . . . . . . . . . . . ....
System Description . . . . . . . . . . . . ...
Component Parts Location . . . . . . . . . ..
SIGNAL BUFFER SYSTEM . . . . . . . ...
System Diagram . . . . . . . . . . . . . ..
System Description . . . . . . . . . . . . .
POWER CONSUMPTION CONTROL SYS-
TEM . . . . . . . . . . . . . . . . .
System Diagram . . . . . . . . . . . . . ..
System Description . . . . . . . . . . . . .
Component Parts Location . . . . . . . . . ..
DIAGNOSIS SYSTEM (BCM) . . . . . . .
COMMON ITEM . . . . . . . . . . . . . . .
COMMON ITEM : CONSULT Function (BCM -
COMMON ITEM) . . . . . . . . . . . . . .
DOOR LOCK . . . . . . . . . . . . . . . ..
DOOR LOCK : CONSULT Function (BCM -
DOOR LOCK) . . . . . . . . . . . . . . ..
REAR DEFOGGER . . . . . . . . . . . . .
REAR DEFOGGER : CONSULT Function (BCM -
REAR DEFOGGER) . . . . . . . . . . . .
BUZZER . . . . . . . . . . . . . . . . . .
BUZZER : CONSULT Function (BCM - BUZZER) .
INT LAMP . . . . . . . . . . . . . . . . ...
INT LAMP : CONSULT Function (BCM - INT
LAMP) . . . . . . . . . . . . . . . . . ..
MULTI REMOTE ENT . . . . . . . . . . . .
MULTI REMOTE ENT : CONSULT Function
(BCM - MULTI REMOTE ENT) . . . . . . . .
HEADLAMP . . . . . . . . . . . . . . . ...
HEADLAMP : CONSULT Function (BCM - HEAD
LAMP) . . . . . . . . . . . . . . . . . ..
WIPER . . . . . . . . . . . . . . . . . .
WIPER : CONSULT Function (BCM - WIPER) . ...
FLASHER . . . . . . . . . . . . . . . . ...
FLASHER : CONSULT Function (BCM - FLASH-
ER) . . . . . . . . . . . . . . . . . . ..
AIR CONDITIONER . . . . . . . . . . . . ...
AIR CONDITIONER : CONSULT Function (BCM -
AIR CONDITIONER) . . . . . . . . . . . ...
INTELLIGENT KEY . . . . . . . . . . . . .
INTELLIGENT KEY : CONSULT Function (BCM -
INTELLIGENT KEY) . . . . . . . . . . . .
COMB SW . . . . . . . . . . . . . . . . ..
COMB SW : CONSULT Function (BCM - COMB
SW) . . . . . . . . . . . . . . . . . . ..
BCM . . . . . . . . . . . . . . . . . . ...
BCM : CONSULT Function (BCM - BCM) . . . ...
August 2012
2012 Pathfinder
BCS-2
IMMU . . . . . . . . . . . . . . . . . . .
IMMU : CONSULT Function (BCM - IMMU) . . ...
BATTERY SAVER . . . . . . . . . . . . ....
BATTERY SAVER : CONSULT Function (BCM -
BATTERY SAVER) . . . . . . . . . . . . .
TRUNK . . . . . . . . . . . . . . . . . ..
TRUNK : CONSULT Function (BCM - TRUNK) . .
THEFT ALM . . . . . . . . . . . . . . . ..
THEFT ALM : CONSULT Function (BCM - THEFT
ALM) . . . . . . . . . . . . . . . . . ...
RETAINED PWR . . . . . . . . . . . . . ...
RETAINED PWR : CONSULT Function (BCM -
RETAINED PWR) . . . . . . . . . . . . ...
SIGNAL BUFFER . . . . . . . . . . . . . ..
SIGNAL BUFFER : CONSULT Function (BCM -
SIGNAL BUFFER) . . . . . . . . . . . . ..
AIR PRESSURE MONITOR . . . . . . . . . ..
AIR PRESSURE MONITOR : CONSULT Function
(BCM - AIR PRESSURE MONITOR) . . . . . .
PANIC ALARM . . . . . . . . . . . . . . ..
PANIC ALARM : CONSULT Function (BCM -
PANIC ALARM) . . . . . . . . . . . . . ..
DTC/CIRCUIT DIAGNOSIS . . . . . . .
U1000 CAN COMM CIRCUIT . . . . . . .
Description . . . . . . . . . . . . . . . ..
DTC Logic . . . . . . . . . . . . . . . ...
Diagnosis Procedure . . . . . . . . . . . ..
POWER SUPPLY AND GROUND CIRCUIT . .
Diagnosis Procedure . . . . . . . . . . . ..
COMBINATION SWITCH INPUT CIRCUIT . ...
Diagnosis Procedure . . . . . . . . . . . ..
Special Repair Requirement . . . . . . . . ...
COMBINATION SWITCH OUTPUT CIRCUIT ...
Diagnosis Procedure . . . . . . . . . . . ...
Special Repair Requirement . . . . . . . . ...
ECU DIAGNOSIS INFORMATION . . . .
BCM (BODY CONTROL MODULE) . . . . ..
Reference Value . . . . . . . . . . . . . .
Terminal Layout . . . . . . . . . . . . . ..
Physical Values . . . . . . . . . . . . . ...
Fail Safe . . . . . . . . . . . . . . . . .
DTC Inspection Priority Chart . . . . . . . ...
DTC Index . . . . . . . . . . . . . . . ..
WIRING DIAGRAM . . . . . . . . .
BCM (BODY CONTROL MODULE) . . . . ..
Wiring Diagram . . . . . . . . . . . . . ...
SYMPTOM DIAGNOSIS . . . . . . .
COMBINATION SWITCH SYSTEM SYMP-
TOMS . . . . . . . . . . . . . . . . .
Symptom Table . . . . . . . . . . . . . ...
PRECAUTION . . . . . . . . . . .
PRECAUTIONS . . . . . . . . . . . . .
Precaution Necessary for Steering Wheel Rota-
tion After Battery Disconnect . . . . . . . . ..
REMOVAL AND INSTALLATION . . . ..
BCM (BODY CONTROL MODULE) . . . . ..
Removal and Installation . . . . . . . . . . .
August 2012
2012 Pathfinder
BCS
INSPECTION AND ADJUSTMENT
BCS-3
< BASIC INSPECTION >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
BASIC INSPECTION
INSPECTION AND ADJUSTMENT
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM)
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Description
INFOID:0000000007354898
BEFORE REPLACEMENT
When replacing BCM, save or print current vehicle specification with CONSULT configuration before replace-
ment.
NOTE:
If “Before Replace ECU” cannot be used, use the “After Replace ECU” or “Instruction Configuration” after replac-
ing BCM.
AFTER REPLACEMENT
CAUTION:
• When replacing BCM, you must perform “After Replace ECU” with CONSULT.
- Complete the procedure of “After Replace ECU” in order.
- If you set incorrect “After Replace ECU”, incidents might occur.
- Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
• When replacing BCM, perform the system initialization (NATS).
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Work Proce-
dure
INFOID:0000000007354899
1.
SAVING VEHICLE SPECIFICATION
CONSULT
Enter "Re/Programming, Configuration" and perform “Before Replace ECU” to save or print current vehicle
specification.
NOTE:
If “Before Replace ECU” cannot be used, use the "After Replace ECU" or "Instruction Configuration" after replac-
ing BCM.
>> GO TO 2.
2.
REPLACE BCM
BCS-53, "Removal and Installation"
.
>> GO TO 3.
3.
WRITING VEHICLE SPECIFICATION
CONSULT
1. Enter "Re/Programming, Configuration".
2. If “Before Replace ECU” operation was performed, automatically an "Operation Log Selection" screen will
be displayed. Select the applicable file from the "Saved Data List" and press “Confirm” to write vehicle
specification. Refer to
BCS-4, "CONFIGURATION (BCM) : Work Procedure"
3. If “Before Replace ECU” operation was not performed, select "After Replace ECU" or "Instruction Configura-
tion" to write vehicle specification. Refer to
BCS-4, "CONFIGURATION (BCM) : Work Procedure"
.
>> GO TO 4.
4.
INITIALIZE BCM (NATS)
Perform BCM initialization. (NATS)
>> Work End.
CONFIGURATION (BCM)
August 2012
2012 Pathfinder
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст