Nissan Terrano model r20 series 2004. Instruction — part 266
Front Oil Seal Replacement
(Front final drive: R180A)
1. Remove front propeller shaft.
2. Loosen drive pinion nut.
Tool number: ST38060002
3. Remove companion flange.
4. Remove front oil seal.
5. Apply multi-purpose grease to cavity at sealing lips of oil seal.
Press front oil seal into carrier.
6. Install companion flange and drive pinion nut.
7. Install propeller shaft.
Tool number:
ST30720000
Front Oil Seal Replacement
(Rear final drive: C200)
1. Remove rear propeller shaft.
2. Loosen drive pinion nut.
Tool number:
KV38104700
SPD733
SPD734
SPD735
SPD736
PD237
ON-VEHICLE SERVICE
PD-10
3. Remove companion flange.
4. Remove front oil seal.
5. Apply multi-purpose grease to cavity at sealing lips of oil seal.
Press front oil seal into carrier.
6. Install companion flange and drive pinion nut in.
7. Install rear propeller shaft.
Tool number:
KV381025S0
SPD737
SPD738
SPD739
ON-VEHICLE SERVICE
Front Oil Seal Replacement
(Rear final drive: C200) (Cont’d)
PD-11
Removal
1. Remove front propeller shaft.
2. Remove drive shaft. Refer to FA section.
3. Remove engine mounting bolts and raise up engine.
4. Remove front final drive together with differential mounting
member.
Installation
1. Install front final drive assembly together with differential
mounting member.
2. Tighten the front final drive securing bolts and nuts following the
procedures below to prevent drive train vibration.
(1) Temporarily tighten nut
q
A
.
(2) Temporarily tighten nut
q
B
.
(3) Tighten bolts
q
C
to the torque of 68 to 87 N
⋅
m (6.9 to 8.9 kg-m,
50 to 64 ft-lb).
(4) Tighten bolts
q
D
to the torque of 68 to 87 N
⋅
m (6.9 to 8.9 kg-m,
50 to 64 ft-lb).
(5) Tighten nut
q
A
to the torque of 68 to 87 N
⋅
m (6.9 to 8.9 kg-m,
50 to 64 ft-lb).
(6) Tighten nut
q
B
to the torque of 68 to 87 N
⋅
m (6.9 to 8.9 kg-m,
50 to 64 ft-lb).
(7) Tighten nuts
q
E
to the torque of 68 to 87 N
⋅
m (6.9 to 8.9 kg-m,
50 to 64 ft-lb).
3. Install drive shaft. Refer to FA section.
4. Install front propeller shaft.
SPD741
SPD742
SPD743
REMOVAL AND INSTALLATION (Front final drive — R180A)
PD-12
Removal
I
Remove propeller shaft.
Insert plug into transfer or transmission after removing pro-
peller shaft.
I
Remove axle shaft. Refer to RA section.
CAUTION:
I
Be careful not to damage spline, sleeve yoke and front oil
seal when removing propeller shaft.
Installation
I
Fill final drive with recommended gear oil.
SPD123
REMOVAL AND INSTALLATION (Rear final drive — C200)
PD-13
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст