Nissan Terrano model r20 series 2004. Instruction — part 244
High Clutch
DISASSEMBLY AND ASSEMBLY
Service procedures for high clutch are essentially the same as
those for reverse clutch, with the following exception:
I
Check of high clutch operation
NAT299
SAT853A
SAT854A
REPAIR FOR COMPONENT PARTS
AT-160
I
Removal and installation of return spring
I
Inspection of high clutch return springs
Inspection standard:
Refer to SDS, AT-202.
I
Inspection of high clutch drive plate
Thickness of drive plate:
Standard
1.52 - 1.67 mm (0.0598 - 0.0657 in)
Wear limit
1.40 mm (0.0551 in)
I
Measurement of clearance between retaining plate and snap
ring
Specified clearance:
Standard
1.8 - 2.2 mm (0.071 - 0.087 in)
Allowable limit
3.2 mm (0.126 in)
Retaining plate:
Refer to SDS, AT-203.
NAT300
SAT829A
SAT845A
SAT858A
REPAIR FOR COMPONENT PARTS
High Clutch (Cont’d)
AT-161
Forward and Overrun Clutches
NAT301
REPAIR FOR COMPONENT PARTS
AT-162
DISASSEMBLY AND ASSEMBLY
Forward and overrun clutches are serviced essentially the same
way as reverse clutch is serviced. However, note the following
exceptions.
I
Check of forward clutch operation.
I
Check of overrun clutch operation.
I
Removal of forward clutch drum
Remove forward clutch drum from transmission case by hold-
ing snap ring.
I
Removal of forward clutch and overrun clutch pistons
1. While holding overrun clutch piston, gradually apply com-
pressed air to oil hole.
2. Remove overrun clutch from forward clutch.
SAT860A
SAT861A
SAT865A
SAT862A
SAT863A
REPAIR FOR COMPONENT PARTS
Forward and Overrun Clutches (Cont’d)
AT-163
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст