Nissan Terrano model r20 series 2004. Instruction — part 256
Replacing Oil Seal
CENTER CASE OIL SEAL
1. Remove front propeller shaft — Refer to PD section.
2. Remove companion flange nut.
3. Remove companion flange.
4. Remove center case oil seal.
5. Install center case oil seal.
Before installing, apply multi-purpose grease to seal lip.
6. Install companion flange.
7. Tighten nut to the specified torque.
: 226 - 324 N
⋅
m (23 - 33 kg-m, 166 - 239 ft-lb)
8. Install front propeller shaft.
YMT010
YMT011
YMT012
SMT488A
YMT013
ON-VEHICLE SERVICE
TF-4
SHIFT SHAFT OIL SEAL
1. Remove front propeller shaft — Refer to PD section.
2. Install companion flange — Refer to “CENTER CASE OIL
SEAL”, TF-4.
3. Remove transfer control lever from transfer outer shift lever.
Then remove outer shift lever.
4. Remove shift shaft oil seal.
Be careful not do damage cross shaft.
5. Install shift shaft oil seal.
Before installing, apply multi-purpose grease to seal lip.
6. Install transfer control linkage.
7. Install companion flange — Refer to “CENTER CASE OIL
SEAL”, TF-4.
8. Install front propeller shaft.
REAR OIL SEAL
1. Remove rear propeller shaft — Refer to PD section.
2. Remove rear oil seal.
YTF001
SMT491A
YMT014
YMT015
ON-VEHICLE SERVICE
Replacing Oil Seal (Cont’d)
TF-5
3. Install rear oil seal.
Before installing apply multi-purpose grease to seal lip.
4. Install rear propeller shaft.
YMT016
ON-VEHICLE SERVICE
Replacing Oil Seal (Cont’d)
TF-6
Removal
I
Drain oil from transfer and transmission.
I
Remove front and rear propeller shafts — Refer to PD section.
I
Insert plug into oil seal after removing propeller shaft.
CAUTION:
Be careful not to damage spline, sleeve yoke and rear oil seal,
when removing propeller shaft.
I
Remove torsion bar spring — Refer to removal and installation
of lower link in FA section. Then remove fifth crossmember.
I
Remove transfer control lever from transfer outer shift lever.
I
Remove transfer from transmission.
WARNING:
Support transfer while removing it.
Installation
I
Apply recommended sealant to mating surface to transmission.
Recommended sealant:
Nissan genuine part (KP610-00250) or equivalent
I
Tighten bolts securing transfer.
Bolt No.
Tightening torque
N
⋅
m (kg-m, ft-lb)
mm (in)
q
1
27 - 36 (2.8 - 3.6, 20 - 26)
45 (1.77)
q
2
27 - 36 (2.8 - 3.6, 20 - 26)
60 (2.36)
SMT478A
YTF001
SMT495A
SMT496A
REMOVAL AND INSTALLATION
TF-7
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст