Nissan Terrano model r20 series 2004. Instruction — part 273
Differential Carrier
1. Mount final drive assembly on Tool.
Tool number:
ST06340000
2. Put match marks on one side bearing cap with paint or punch
to ensure that it is replaced in proper position during reassem-
bly.
Bearing caps are line-bored during manufacture and should
be put back in their original places.
3. Remove side lock fingers and side bearing caps.
4. Remove side bearing adjuster with Tool.
Tool number:
ST32580000
5. Remove differential case assembly with a pry bar.
SPD683
SPD249
YPD006
SPD684
SPD685
DISASSEMBLY (C200)
PD-38
Be careful to keep the side bearing outer races together with
their respective inner cones — do not mix them up.
6. Remove drive pinion nut with Tool.
Tool number: KV38104700
7. Remove companion flange with puller.
8. Take out drive pinion together with pinion rear bearing inner
cone, drive pinion bearing spacer and pinion bearing adjusting
shim.
9. Remove front oil seal and pinion front bearing inner cone.
10. Remove pinion bearing outer races with a brass drift.
SPD011
SPD012
SPD686
SPD687
SPD563
DISASSEMBLY (C200)
Differential Carrier (Cont’d)
PD-39
11. Remove pinion rear bearing inner cone and drive pinion adjust-
ing washer.
Tool number:
ST30031000
Differential Case
1. Remove side bearing inner cones.
To prevent damage to bearing, engage puller jaws in groove.
Tool number:
q
A
ST33051001
q
B
ST33061000
Be careful not to confuse left and right hand parts.
2. Loosen ring gear bolts in a criss-cross fashion.
3. Tap ring gear off differential case with a soft hammer.
Tap evenly all around to keep ring gear from binding.
SPD018
SPD688
SPD022
SPD024
DISASSEMBLY (C200)
Differential Carrier (Cont’d)
PD-40
4. Separate differential case.
Put match marks on both L.H. and R.H. differential cases.
SPD716
DISASSEMBLY (C200)
Differential Case (Cont’d)
PD-41
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст