Nissan Terrano model r20 series 2004. Instruction — part 281
[Example]
(Measures taken at one side):
(1)
Angle
Specified value
Measured
Change
Camber angle
0°30
′
0°5
′
+0°25
′
Caster angle
1°54
′
2°10
′
−0°16
′
The above values relate to the graph below:
Shim thickness selection graph
(2) Obtain intersection point of lines in accordance with the graph.
Front: 1.4 mm
Rear: 2.0 mm
(3) Choose shims which are nearest to the values found in the
graph:
Front: 1.6 mm
Rear: 2.0 mm
(4) If shim thicknesses as calculated appear not to be available,
combinations of different shims should be used to meet the
desired total thickness of the shims.
EFA015
CHECK AND ADJUSTMENT
Front Wheel Alignment (Cont’d)
FA-10
TOE-IN
1. Mark a base line across the tread.
After lowering front of vehicle, move it up and down to elimi-
nate friction, and set steering wheel in straight ahead position.
2. Measure toe-in.
Measure distance “A” and “B” at the same height as hub cen-
ter.
Toe-in (Unladen):
Refer to SDS, FA-39.
Toe-in = A − B
3. Adjust toe-in by varying the length of steering tie-rods.
(1) Loosen clamp bolts or lock nuts.
(2) Adjust toe-in by turning the left and right tie-rod tubes an equal
amount.
Make sure that the tie-rod bars are screwed into the tie-rod
tube more than 32.5 mm (1.280 in).
Make sure that the tie-rods are the same length.
Standard length (A = B):
287 mm (11.30 in)
(3) Tighten clamp bolts or lock nuts, to the specified torque.
SMA123
EFA010
EFA011
YFA018
YFA019
CHECK AND ADJUSTMENT
Front Wheel Alignment (Cont’d)
FA-11
FRONT WHEEL TURNING ANGLE
1. Set wheels in straight ahead position and then move vehicle
forward until front wheels rest on turning radius gauge properly.
2. Rotate steering wheel all the way right and left; measure turn-
ing angle.
Wheel turning angle:
Refer to SDS, FA-39.
3. Adjust by stopper bolt if necessary.
Standard length “L
2
”:
26.5 mm (1.043 in)
Drive Shaft
I
Check for grease leakage or other damage.
SMA127
SFA898
EFA016
SFA901
CHECK AND ADJUSTMENT
Front Wheel Alignment (Cont’d)
FA-12
YFA020
FRONT AXLE
FA-13
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст