Nissan Murano Z51. Instruction — part 194
AV
REAR VIEW CAMERA
AV-555
< REMOVAL AND INSTALLATION >
[BOSE AUDIO WITHOUT NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
1.
Draw lines on rearward area of the vehicle passing through the
following points: 200 mm (7.87 in) from both sides of the vehicle,
and 0.5 m (1.64 ft), 1.0 m (3.28 ft) from the rear end of the
bumper.
2.
Set into “Adjust offset of rear view camera” mode of Confirma-
tion / Adjustment mode.
3.
Rotate the center dial, and then select the guiding line pattern so
that its angle is aligned with the correction line of the rear of the
vehicle.
4.
Make fine adjustment to the correction line of the rear of the
vehicle with up/down/left/right switches so that its position is
aligned with the guiding line. Press “OK” switch and record the
adjusted guiding line position to the camera control unit.
CAUTION:
Never operate other function such as pressing BACK while writing index data.
If Confirmation/Adjustment mode does not function in the above procedure, perform one of the
following service to adjust the index again.
• Remove battery for five min. Then reconnect battery.
• Remove camera control unit connector for five min. Then reconnect camera control unit connec-
tor.
SKIB3691E
Selected pattern
: 7
Up/Down adjustment range
:
−
20 – 20
Left/Right adjustment range
:
−
20 – 20
SKIB3689E
AV-556
< REMOVAL AND INSTALLATION >
[BOSE AUDIO WITHOUT NAVIGATION]
STEERING ANGLE SENSOR
STEERING ANGLE SENSOR
Exploded View
INFOID:0000000005528657
REMOVAL
(for USA and Canada) or
(for Mexico).
DISASSEMBLY
Removal and Installation
INFOID:0000000005528658
REMOVAL
1.
Remove spiral cable.
2.
Remove steering angle sensor from spiral cable.
INSTALLATION
Install in the reverse order of removal.
JSNIA0135ZZ
1.
Spiral cable
2.
Steering angle sensor
AV
ROOF ANTENNA
AV-557
< REMOVAL AND INSTALLATION >
[BOSE AUDIO WITHOUT NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
ROOF ANTENNA
Exploded View
INFOID:0000000005528659
Removal and Installation
INFOID:0000000005528660
REMOVAL
1.
Remove headlining assembly (rear) to secure work space between vehicle and headlining. Refer to
26, "NORMAL ROOF : Exploded View"
[without sunroof] or
INT-30, "SUNROOF : Exploded View"
[with
sunroof].
2.
Disconnect AM/FM main connector and satellite radio antenna connector.
3.
Remove antenna base & satellite radio nut, and then remove antenna base &satellite radio antenna from
roof panel.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
When Antenna base & satellite radio antenna mounting nut tightening torque is loose, be careful
about tightening torque. Antenna sensitivity becomes poor, and when it is excessive, roof panel may
become deformed.
JPNIA0786ZZ
1.
Rod antenna
2.
Antenna bade & satellite radio an-
tenna
Antenna base & satellite ra-
dio antenna mounting nut
: 6.5 N·m (0.66 kg-m, 58 in-lb)
AV-558
< REMOVAL AND INSTALLATION >
[BOSE AUDIO WITHOUT NAVIGATION]
SATELLITE RADIO TUNER
SATELLITE RADIO TUNER
Exploded View
INFOID:0000000005528661
Removal and Installation
INFOID:0000000005528662
REMOVAL
1.
Remove luggage floor finisher front. Refer to
2.
Remove satellite radio tuner (1) with TEL adapter unit as a sin-
gle unit from the body.
3.
Remove bracket screws, and them remove satellite tuner.
INSTALLATION
Install in the reverse order of removal.
1.
Satellite radio tuner
2.
Bracket LH
3.
TEL adapter unit
4.
Bracket RH
JPNIA0784ZZ
:
Vehicle front
JPNIA0785ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст