Nissan Murano Z51. Instruction — part 937
INT-18
< REMOVAL AND INSTALLATION >
DOOR FINISHER
8.
Remove bolt (B) located behind armrest finisher with tool (A).
9.
Remove seat memory switch finisher (1) and rear heated seat (LH/RH) switch finisher (2) with remover
tool (A), then disconnect the harness connectors. (With sunroof)
10. Insert remover tool (A) between door finisher and door panel to
disengage door finisher mounting clips, starting from the bottom
and working to the top.
11. Pull up rear door finisher and pull out.
12. Disconnect lock knob cable (1) and inside handle cable (2) from
rear door inside handle (3).
13. Remove rear door finisher.
14. Remove the inside handle after removing rear door finisher. Refer to
.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
JMJIA1356ZZ
: Pawl
JMJIA1358ZZ
: Clip
JMJIA1360ZZ
JMJIA1359ZZ
DOOR FINISHER
INT-19
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
K
L
M
A
B
INT
N
O
P
When installing door finisher, check that clips are securely fitted in panel holes on body, and then
press them in.
INT-20
< REMOVAL AND INSTALLATION >
BODY SIDE TRIM
BODY SIDE TRIM
Exploded View
INFOID:0000000005513291
Removal and Installation
INFOID:0000000005513292
CAUTION:
Wrap the tip of flat-bladed screwdriver with a cloth when removing metal clips from garnishes.
REMOVAL
FRONT PILLAR GARNISH
1.
Remove front body side welt partially.
1.
Front body side welt
2.
Rear body side welt
3.
Front pillar garnish
4.
Front kicking plate (inner)
5.
Dash side finisher
6.
Rear kicking plate (inner)
7.
Center pillar lower garnish
8.
Center pillar upper garnish
9.
Front kicking plate (outer)
10. Rear kicking plate (outer)
11. Bolt cover
: Clip
: Pawl
: Metal clip
Refer to
for symbols in the figure.
JMJIA1363ZZ
BODY SIDE TRIM
INT-21
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
K
L
M
A
B
INT
N
O
P
2.
Disengage front pillar garnish (1) mounting clips with remover
tool (A).
3.
Pull front pillar garnish (1) partially toward the vehicle.
4.
Insert remover tool (A) between mounting clip bottom side and body side to disengage front pillar garnish
(1) mounting clip.
5.
Once free, pull front pillar garnish (1) upwards to disengage the lower locating tab from instrument panel.
6.
Remove front pillar garnish (1).
FRONT KICKING PLATE INNER
1.
Disengage the pawls and metal clip from the body panel with
remover tool (A).
2.
Remove front kicking plate inner (1).
FRONT KICKING PLATE OUTER
1.
Disengage the pawls from the body panel with remover tool (A).
2.
Remove front kicking plate outer (1).
DASH SIDE FINISHER
1.
Remove front kicking plate inner.
: Clip
JMJIA1364ZZ
JMJIA2757ZZ
: Pawl
: Metal clip
JMJIA1365ZZ
: Pawl
JMJIA1366ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст