Nissan Murano Z51. Instruction — part 1190
RF-100
< REMOVAL AND INSTALLATION >
SUNSHADE MOTOR ASSEMBLY
Removal and Installation
INFOID:0000000005516870
REMOVAL
CAUTION:
• Before removing sunshade motor, check that glass lid is fully closed.
• After removing sunshade motor, never attempt to rotate sunshade motor assembly as a single unit.
1.
Remove the headlining. Refer to
INT-30, "SUNROOF : Removal and Installation"
2.
Disconnect connector (A) from sunshade motor assembly (1).
Remove sunshade motor assembly mounting screws (B), and
then remove sunshade motor assembly.
INSTALLATION
CAUTION:
Before installing the sunshade motor assembly, be sure to the place the link and wire assembly in the
symmetrical and fully closed position.
1.
Move the sunshade motor assembly laterally by little so that the gear is completely engaged into the wire
on the sunroof unit assembly and mounting surface becomes parallel. Then secure the sunshade motor
assembly with screws.
2.
Install the headlining. Refer to
INT-30, "SUNROOF : Removal and Installation"
.
JMKIA1909ZZ
SUNROOF UNIT ASSEMBLY
RF-101
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
RF
N
O
P
SUNROOF UNIT ASSEMBLY
Exploded View
INFOID:0000000005516871
REMOVAL
1.
Roof side finisher RH
2.
Rear link cover
3.
TORX bolt
4.
Glass lid
5.
Roof side finisher LH
6.
Inner blind
7.
Sunroof unit assembly
8.
Sunroof bracket
9.
Drain hose
10. Drain connector
11.
Drain plug
12. Sunroof motor assembly
JMKIA1901ZZ
RF-102
< REMOVAL AND INSTALLATION >
SUNROOF UNIT ASSEMBLY
DISASSEMBLY
13. Sunshade motor assembly
Refer to
for symbols in the figure.
1.
Windshield glass
2.
Front sunroof glass
3.
Adhesive
4.
Sunroof frame
5.
Roof panel
6.
Primer
7.
Roof side finisher
8.
Rear sunroof glass
Refer to
for symbols in the figure.
JMKIA1898GB
SUNROOF UNIT ASSEMBLY
RF-103
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
RF
N
O
P
Removal and Installation
INFOID:0000000005516872
REMOVAL
CAUTION:
• Always work with a helper.
• When taking sunroof unit assembly out, use cloths to protect the seats and trim from damage.
• Never reuse the front and rear sunroof glass which has been removed once.
1.
Remove the headlining. Refer to
INT-30, "SUNROOF : Removal and Installation"
2.
Remove the glass lid. Refer to
RF-95, "Removal and Installation"
3.
Disconnect drain hoses.
4.
Remove the sunroof brackets (LH/RH).
5.
Remove nuts and bolts from the front end, side rail and rear end.
1.
Weather-strip
2.
Wind deflector
3.
Sunroof frame
4.
Front sunshade
5.
Sunshade cover
6.
Rear sunshade
Refer to
JMKIA1902ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст