Nissan Murano Z51. Instruction — part 1464
IN-VEHICLE SENSOR
VTL-27
< REMOVAL AND INSTALLATION >
[WITHOUT 7 INCH DISPLAY]
C
D
E
F
G
H
J
K
L
M
A
B
VTL
N
O
P
IN-VEHICLE SENSOR
Exploded View
INFOID:0000000005517115
Removal and Installation
INFOID:0000000005517116
REMOVAL
1.
Remove the instrument lower panel LH. Refer to
.
2.
Remove the mounting screw (A), and then remove the in-vehicle
sensor (1).
INSTALLATION
Install in the reverse order of removal.
1.
In-vehicle sensor
2.
Instrument lower panel LH
JPIIA0557ZZ
JPIIA0558ZZ
VTL-28
< REMOVAL AND INSTALLATION >
[WITHOUT 7 INCH DISPLAY]
SUNLOAD SENSOR
SUNLOAD SENSOR
Exploded View
INFOID:0000000005517117
Removal and Installation
INFOID:0000000005517118
REMOVAL
1.
Disconnect the sunload sensor connector, and then remove the
sunload sensor (1).
INSTALLATION
Install in the reverse order of removal.
1.
Sunload sensor
JPIIA0559ZZ
JPIIA0560ZZ
INTAKE SENSOR
VTL-29
< REMOVAL AND INSTALLATION >
[WITHOUT 7 INCH DISPLAY]
C
D
E
F
G
H
J
K
L
M
A
B
VTL
N
O
P
INTAKE SENSOR
Exploded View
INFOID:0000000005517119
Removal and Installation
INFOID:0000000005517120
REMOVAL
1.
Remove the evaporator pipe assembly. Refer to
.
2.
Slide the evaporator (1) toward the right side of the vehicle, and
then remove the intake sensor (2).
INSTALLATION
Note the following, and install in the reverse order of removal.
CAUTION:
• Replace the O-ring with a new one. Apply a coat of compressor oil to the O-ring prior to installation.
• Install the intake sensor in the same position as the removed intake sensor when replacing the
intake sensor.
• Do not rotate the bracket insertion part when removing and installing the intake sensor.
• Check for refrigerant leakage when charging refrigerant.
1.
Heater & cooling unit assembly
2.
Intake sensor bracket
3.
Intake sensor
4.
Evaporator assembly
5.
Evaporator cover
6.
Air mix door motor (passenger side)
7.
Foot duct (right)
8.
Cooler pipe grommet
JPIIA1303ZZ
JPIIA0907ZZ
VTL-30
< REMOVAL AND INSTALLATION >
[WITHOUT 7 INCH DISPLAY]
BLOWER UNIT
BLOWER UNIT
Exploded View
INFOID:0000000005517121
REMOVAL
DISASSEMBLY
1.
Blower unit assembly
2.
Heater & cooling unit assembly
3.
Steering member
4.
Instrument stay
5.
Instrument panel assembly
for symbols in the figure.
JPIIA1224GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст