Nissan Silvia. Instruction — part 238
Removal and Installation
NMEM0022
SEM626G
GI
MA
LC
EC
FE
CL
MT
AT
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
ENGINE ASSEMBLY
Removal and Installation
EM-65
WARNING:
I
Position vehicle on a flat and solid surface.
I
Place chocks at front and back of rear wheels.
I
Do not remove engine until exhaust system has com-
pletely cooled off, otherwise you may burn yourself and/or
fire may break out in fuel line.
I
Before disconnecting fuel hose, release pressure. Refer to
EC-27, “Fuel Pressure Release”.
I
Be sure to lift engine and transmission in a safe manner.
I
For engines not equipped with engine slingers, attach
proper slingers and bolts described in PARTS CATALOG.
CAUTION:
I
When lifting engine, be sure to clear surrounding parts.
Use special care near accelerator wire casing, brake lines
and brake master cylinder.
I
In lifting the engine, always use engine slingers in a safe
manner.
REMOVAL
NMEM0022S01
1.
Remove transmission. Refer AT-208 or MT-12, “Removal”.
2.
Remove engine under covers and hood.
3.
Drain coolant from both cylinder block and radiator. Refer to
LC-15, “Changing Engine Coolant”.
4.
Drain engine oil.
5.
Remove air cleaner assembly and duct.
6.
Remove the battery and battery tray.
7.
Disconnect the following:
I
Vacuum hoses
I
Heater hoses
I
A/T cooler hoses
I
Power steering hoses
I
Fuel lines
I
Wires
I
Harnesses and connectors
I
Throttle cable
8.
Remove the cooling fans, radiator and reservoir tank.
9.
Remove front exhaust pipe.
10. Remove the drive belts.
11. Remove power steering oil pump and A/C compressor.
12. Attach a suitable engine slinger to cylinder head.
13. Set a suitable hoist on engine slinger.
ENGINE ASSEMBLY
Removal and Installation (Cont’d)
EM-66
14. Remove engine mounting bolts from both sides, then slowly
raise engine.
SEM035F
15. Remove engine as shown.
INSTALLATION
NMEM0022S02
Install in the reverse order of removal.
GI
MA
LC
EC
FE
CL
MT
AT
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
ENGINE ASSEMBLY
Removal and Installation (Cont’d)
EM-67
Components
NMEM0023
SEM625G
1.
Rear oil seal retainer
2.
Cylinder block
3.
Water pump
4.
Front cover with oil pump
5.
Oil strainer
6.
Thrust bearing
7.
Crankshaft
8.
Connecting rod bushing
9.
Piston rings
10. Piston
11. Piston pin
12. Connecting rod
13. Connecting rod bearing
14. Baffle plate
15. Main bearing beam
16. Main bearing cap
17. Pilot converter
18. Drive plate
19. Reinforcement plate
20. Flywheel
21. Pilot bushing
22. Rear plate
23. Main bearing
24. Oil jet
25. Baffle plate
CYLINDER BLOCK
Components
EM-68
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст