Nissan Silvia. Instruction — part 115
JBT151A
Repairing Water Leaks for Windshield and Windows
NMBT0023S0301
Leaks can be repaired without removing and reinstalling glass.
If water is leaking between the urethane adhesive material and
body or glass, determine the extent of leakage. This can be
done by applying water to the windshield area while pushing
glass outward.
To stop the leak, apply primer (if necessary) and then urethane
adhesive to the leak point.
GI
MA
EM
LC
EC
FE
CL
MT
AT
PD
AX
SU
BR
ST
RS
HA
SC
EL
IDX
WINDSHIELD AND WINDOWS
Removal and Installation (Cont’d)
BT-51
Removal and Installation
NMBT0024
CAUTION:
Be careful not to scratch door rearview mirror body.
★
For Wiring Diagram, refer to EL-110, “DOOR MIRROR” for details.
1. Remove front corner of door inner cover.
2. Disconnect door mirror harness connector.
3. Remove nuts securing door mirror assembly.
4. Remove the mirror glass. Do not insert flat-bladed screwdriver too far.
JBT152A
DOOR MIRROR
Removal and Installation
BT-52
Alignment
NMBT0026
I
All dimensions indicated in figures are actual ones.
I
When using a tracking gauge, adjust both pointers to equal length. Then check the pointers and gauge
itself to make sure there is no free play.
I
When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
I
Measurements should be taken at the center of the mounting holes.
I
An asterisk (*) following the value at the measuring point indicates that the measuring point on the other
side is symmetrically the same value.
I
The coordinates of the measurement points are the distances measured from the standard line of “X”, “Y”
and “Z”.
SBF874GB
GI
MA
EM
LC
EC
FE
CL
MT
AT
PD
AX
SU
BR
ST
RS
HA
SC
EL
IDX
BODY (ALIGNMENT)
Alignment
BT-53
ENGINE COMPARTMENT
NMBT0026S01
Measurement
NMBT0026S0101
SBT091A
BODY (ALIGNMENT)
Alignment (Cont’d)
BT-54
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст