Nissan Silvia. Instruction — part 62
SAT444K
ASSEMBLY
NMAT0131
1.
Install D-ring and oil seal on piston.
I
Apply ATF to both parts.
SAT848A
2.
Install piston assembly by turning it slowly and evenly.
I
Apply ATF to inner surface of drum.
3.
Install spring retainer.
SAT843A
4.
Install snap ring while compressing clutch springs.
SAT850A
I
Do not align snap ring gap with spring retainer stopper.
SAT842A
5.
Install drive plates, driven plates, retaining plate and dish plate.
6.
Install snap ring.
GI
MA
EM
LC
EC
FE
CL
MT
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
REPAIR FOR COMPONENT PARTS
Reverse Clutch (Cont’d)
AT-245
SAT445K
7.
Measure clearance between retaining plate and snap ring. If
not within allowable limit, select proper retaining plate.
Specified clearance:
Standard
0.5 - 0.8 mm (0.020 - 0.031 in)
Allowable limit
1.2 mm (0.047 in)
Retaining plate:
Refer to SDS, AT-290.
SAT442K
8.
Check operation of reverse clutch.
Refer to “DISASSEMBLY” of Reverse Clutch, AT-243.
High Clutch
COMPONENTS
NMAT0132
SAT144J
REPAIR FOR COMPONENT PARTS
Reverse Clutch (Cont’d)
AT-246
SAT853A
DISASSEMBLY AND ASSEMBLY
NMAT0133
Service procedures for high clutch are essentially the same as
those for reverse clutch, with the following exception:
SAT854A
I
Check of high clutch operation
SAT855AA
I
Removal and installation of return spring
SAT829A
I
Inspection of high clutch return springs
Inspection standard:
Refer to SDS, AT-289.
SAT845A
I
Inspection of high clutch drive plate
Thickness of drive plate:
Standard
1.52 - 1.67 mm (0.0598 - 0.0657 in)
Wear limit
1.40 mm (0.0551 in)
GI
MA
EM
LC
EC
FE
CL
MT
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
REPAIR FOR COMPONENT PARTS
High Clutch (Cont’d)
AT-247
SAT858A
I
Measurement of clearance between retaining plate and snap
ring
Specified clearance:
Standard
1.8 - 2.2 mm (0.071 - 0.087 in)
Allowable limit
3.2 mm (0.126 in)
Retaining plate:
Refer to SDS, AT-290.
REPAIR FOR COMPONENT PARTS
High Clutch (Cont’d)
AT-248
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст