Nissan Terrano r20e. Instruction — part 413

HOW TO ERASE SELF-DIAGNOSIS RESULTS

With CONSULT-II

“SELF-DIAG [CURRENT]”
A current self-diagnosis result is displayed on the CONSULT-II screen in real time.
After the malfunction is repaired completely, no malfunction is detected on “SELF-DIAG [CURRENT]”.

“SELF-DIAG [PAST]”
Return to the “SELF-DIAG [CURRENT]” CONSULT-II screen by pushing “BACK” key of CONSULT-II and
select “SELF-DIAG [CURRENT]” in SELECT DIAG MODE. Touch “ERASE” in “SELF-DIAG [CURRENT]”
mode.

NOTE:
If the memory of the malfunction in “SELF-DIAG [PAST]” is not erased, the User mode shows the sys-
tem malfunction by the operation of the warning lamp even if the malfunction is repaired completely.

“TROUBLE DIAG RECORD”
The memory of “TROUBLE DIAG RECORD” cannot be erased.

Without CONSULT-II

After a malfunction is repaired, switch the ignition “OFF” for at least one second, then back “ON”. Diagnosis
mode returns to the User mode. At that time, the self-diagnostic result is cleared.

SRS701

SUPPLEMENTAL RESTRAINT SYSTEM (SRS)

Trouble Diagnoses Introduction (Cont’d)

RS-28

How to Perform Trouble Diagnoses for Quick
and Accurate Repair

A good understanding of the malfunction conditions can make troubleshooting faster and more accurate.
In general, each customer feels differently about a malfunction. It is important to fully understand the symp-
toms or conditions for a customer complaint.

INFORMATION FROM CUSTOMER

WHAT . . Vehicle model
WHEN . . Date, Frequencies
WHERE . . Road conditions
HOW . . Operating conditions, Symptoms

PRELIMINARY CHECK

Check that the following parts are in good order.

Battery [Refer to SC-3, “BATTERY”.]

Fuse [Refer to EL-10, “Fuse”, “POWER SUPPLY ROUTING”.]

System component-to-harness connections

SUPPLEMENTAL RESTRAINT SYSTEM (SRS)

RS-29