Nissan Terrano r20e. Instruction — part 33
c. Remove oil seal from adapter case.
I
Do not remove oil seal unless it is to be replaced.
d. Remove revolution sensor from adapter case.
e. Remove O-ring from revolution sensor.
19. Remove output shaft and parking gear.
a. Remove rear snap ring from output shaft.
b. Slowly push output shaft all the way forward.
I
Do not use excessive force.
c. Remove snap ring from output shaft.
d. Remove output shaft and parking gear as a unit from transmis-
sion case.
e. Remove parking gear from output shaft.
SAT756I
SAT757I
SAT960A
SAT957A
SAT109B
DISASSEMBLY
Disassembly (Cont’d)
AT-129
f.
Remove needle bearing from transmission case.
20. Remove rear side clutch and gear components.
a. Remove front internal gear.
b. Remove bearing race from front internal gear.
c. Remove needle bearing from rear internal gear.
d. Remove rear internal gear, forward clutch hub and overrun
clutch hub as a set from transmission case.
SAT033B
SAT954A
SAT110B
SAT111B
SAT951A
DISASSEMBLY
Disassembly (Cont’d)
AT-130
e. Remove needle bearing from overrun clutch hub.
f.
Remove overrun clutch hub from rear internal gear and forward
clutch hub.
g. Remove thrust washer from overrun clutch hub.
h. Remove forward clutch assembly from transmission case.
21. Remove band servo and accumulator components.
a. Remove band servo retainer from transmission case.
b. Apply compressed air to oil hole until band servo piston comes
out of transmission case.
I
Hold piston with a rag and gradually direct air to oil hole.
c. Remove return springs.
SAT148G
SAT036B
SAT037B
SAT038B
SAT039B
DISASSEMBLY
Disassembly (Cont’d)
AT-131
d. Remove springs from accumulator pistons
q
B
,
q
C
and
q
D
.
e. Apply compressed air to each oil hole until piston comes out.
I
Hold piston with a rag and gradually direct air to oil hole.
Identification of accumulator pistons
q
A
q
B
q
C
q
D
Identification of oil holes
q
a
q
b
q
c
q
d
f.
Remove O-ring from each piston.
22. Remove instruction shaft components, if necessary.
a. Hold width across flats of manual shaft (outside the transmis-
sion case) and remove lock nut from shaft.
b. Remove retaining pin from transmission case.
c. While pushing detent spring down, remove instruction plate and
parking rod from transmission case.
SAT040BA
SAT523GA
SAT041B
SAT042B
SAT935A
DISASSEMBLY
Disassembly (Cont’d)
AT-132
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст