Nissan Terrano r20e. Instruction — part 389
2. Remove snap ring.
3. Remove pushed out journal bearing by lightly tapping yoke with
a hammer, taking care not to damage journal and yoke hole.
4. Remove bearing at opposite side in above operation.
Put marks on disassembled parts so that they can be rein-
stalled in their original positions from which they were
removed.
Assembly
JOURNAL
1. Assemble journal bearing. Apply recommended multi-purpose
grease on bearing inner surface.
When assembling, be careful that needle bearing does not fall
down.
2. Select snap rings that will provide specified play in axial direc-
tion of journal, and install them. (Refer to PD-57.)
Select snap rings with a difference in thickness at both sides
within 0.06 mm (0.0024 in).
SPD731
SPD732
SPD131
SPD133
SPD134
PROPELLER SHAFT
Disassembly (Cont’d)
PD-8
3. Adjust thrust clearance between bearing and snap ring to zero
by tapping yoke.
4. Check to see that journal moves smoothly and check for axial
play.
Axial play: Less than 0.02 mm (0.0008 in)
SPD732
SPD135
PROPELLER SHAFT
Assembly (Cont’d)
PD-9
Front Oil Seal Replacement
(Front final drive: R180A)
1. Remove front propeller shaft.
2. Loosen drive pinion nut.
Tool number: ST38060002
3. Remove companion flange.
4. Remove front oil seal.
5. Apply multi-purpose grease to cavity at sealing lips of oil seal.
Press front oil seal into carrier.
6. Install companion flange and drive pinion nut.
7. Install propeller shaft.
Tool number:
ST30720000
Front Oil Seal Replacement
(Rear final drive: H233B)
1. Remove rear propeller shaft.
2. Loosen drive pinion nut.
Tool number:
KV38104700
SPD733
SPD734
SPD735
SPD736
PD237
ON-VEHICLE SERVICE
PD-10
3. Remove companion flange.
4. Remove front oil seal.
5. Apply multi-purpose grease to cavity at sealing lips of oil seal.
Press front oil seal into carrier.
6. Install companion flange and drive pinion nut in.
7. Install rear propeller shaft.
Tool number:
KV381025S0
SPD737
SPD738
SPD739
ON-VEHICLE SERVICE
Front Oil Seal Replacement
(Rear final drive: H233B) (Cont’d)
PD-11
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст