Nissan Terrano r20e. Instruction — part 397
11. Remove pinion rear bearing inner cone and drive pinion adjust-
ing washer.
Tool number:
ST30031000
Differential Case
1. Remove side bearing inner cones.
To prevent damage to bearing, engage puller jaws in groove.
Tool number:
q
A
ST33051001
q
B
ST33061000
Be careful not to confuse left and right hand parts.
2. Loosen ring gear bolts in a criss-cross fashion.
3. Tap ring gear off differential case with a soft hammer.
Tap evenly all around to keep ring gear from binding.
SPD018
SPD688
SPD022
SPD024
DISASSEMBLY (H233B)
Differential Carrier (Cont’d)
PD-40
4. Separate differential case.
Put match marks on both L.H. and R.H. differential cases.
SPD716
DISASSEMBLY (H233B)
Differential Case (Cont’d)
PD-41
Ring Gear and Drive Pinion
Check gear teeth for scoring, cracking or chipping.
If any damaged part is evident, replace ring gear and drive pinion
as a set (hypoid gear set).
Differential Case Assembly
Check mating surfaces of differential case, side gears, pinion mate
gears, pinion mate shaft, and thrust washers.
Bearing
1. Thoroughly clean bearing.
2. Check bearings for wear, scratches, pitting or flaking.
Check tapered roller bearing for smooth rotation. If damaged,
replace outer race and inner cone as a set.
EPD009
SPD715
INSPECTION (H233B)
PD-42
CAUTION:
Do not run engine when one rear wheel is off the ground.
Preparation for Disassembly
CHECKING DIFFERENTIAL TORQUE
Measure differential torque with Tool.
If it is not within the specifications, inspect components of limited
slip differential.
Differential torque:
353 - 392 N
⋅
m (36 - 40 kg-m, 260 - 289 ft-lb)
Assembly:
KV38105250
Tool number:
q
A
KV38105210
q
B
KV38105220
YPD004
SPD415
LIMITED SLIP DIFFERENTIAL (H233B)
PD-43
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст