Nissan Terrano r20e. Instruction — part 280
Removal and Installation
CAUTION:
To avoid damaging intercooler core when flushing intercooler
with high pressure water, apply water straight to the core face.
YEM037
INTERCOOLER
ZD
EM-11
Removal and Installation
YEM041
INTAKE MANIFOLD
ZD
EM-12
REMOVAL
1. Remove the following parts.
I
Drain engine coolant. Refer to MA section, “Changing Engine
Coolant”.
I
Remove engine cover. Refer to the figure at left.
I
Remove intercooler.
I
Remove air hose (on throttle body side).
I
Remove injection tube.
I
Remove or relocate wires/harnesses and tubes/pipes.
2. Remove intake manifold in the reverse order of that shown in
the figure.
Inspection
Clean surface of intake manifold.
Use a reliable straightedge and feeler gauge to check the flatness
of intake manifold surface.
Intake manifold surface flatness:
Limit 0.2 mm (0.008 in)
INSTALLATION
1. Tighten intake manifold in the numerical order shown in the
figure.
: 25 - 28 N
⋅
m (2.5 - 2.9 kg-m, 18 - 20 ft-lb)
2. Install in the reverse order of removal.
SEM293G
SEM294G
INTAKE MANIFOLD
ZD
Removal and Installation (Cont’d)
EM-13
Removal and Installation
REMOVAL
1. Remove the following parts.
I
Undercover
I
Under guard
I
Engine coolant (drain)
Refer to MA section, “Changing Engine Coolant”.
I
Exhaust front tube
Refer to FE section, “Removal and Installation”, “EXHAUST
SYSTEM”.
I
Remove wires, harnesses, tubes and pipes.
YEM038
SEM296G
CATALYST AND TURBOCHARGER
ZD
EM-14
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст