Nissan Primera P11. Instruction — part 306
System Description
The auto level control unit is designed to adjust the beam angle of the headlamp in response to the load-
ing conditions of the vehicle. It is not designed to compensate for the dynamic handling of the vehicle.
The vehicle’s front and rear height is measured by sensors attached to the front stabilizer bar and the rear
suspension lateral link arm. The sensors provide a signal to the auto level control unit, which calculates the
correct headlamp aiming position and sends a signal to the aiming motors.
Initialisation
After the replacement or adjustment of any suspension sensor, the system must be self calibrated. This is
achieved as follows.
The vehicle must be empty, since any load will result in an invalid calibration. From outside of the vehicle
turn ignition on and then within 7 seconds the light switch must be turned from off to side lights on position,
5 times, finishing with the lamps in the on position.
The headlamps will then move to the highest, then the lowest then the normal position to indicate that the
calibration is successful, as can be seen by the moving beam pattern.
After successful calibration the headlamps must then be aimed in the conventional manner. Refer to EL-70.
HEADLAMP — Headlamp Aiming Control (Auto) —
EL-91
Component Parts and Harness
Connector Location
NEL528
Auto level control unit
Rear sensor
Headlamp aiming motor RH
Front sensor
Headlamp aiming motor LH
Rear sensor
Auto level control unit
Front sensor
Headlamp
aiming motor
HEADLAMP — Headlamp Aiming Control (Auto) —
EL-92
Wiring Diagram — H/AIM —
AUTO
YEL836C
HEADLAMP — Headlamp Aiming Control (Auto) —
EL-93
YEL837C
HEADLAMP — Headlamp Aiming Control (Auto) —
Wiring Diagram — H/AIM — (Cont’d)
EL-94
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст