Nissan Primera P11. Instruction — part 63
p
18
Rear combination lamp
●
Rear combination lamps are installed with nuts and butyl sealant.
●
When removing inside rear combination lamp (installed on back door), first remove “Back door finisher”.
Refer to
p
22
Back door finisher.
p
19
Center mud guard
NBT056
Heat gun
Heat gun
Butyl seal
Heat gun
SEC. 265
Heat gun
Butyl seal
●
Apply butyl seal evenly as it tends to become thin in
the corners.
●
Warm up lamp assembly area to a temperature of a
little below 60°C (140°F).
NBT046
SEC. 767
Double-faced adhesive tape
CF118
C205
EXTERIOR
BT-37
p
20
Front hood grille
p
21
Roof rail
NBT047
Hook
Hook
Hook
NBF280
Roof rail
5.1 - 6.4 N·m
(0.52 - 0.65 kg-m,
45.1 - 56.6 in-lb)
Clip
Clip
Hook
Pawl
Hook
Front
Center
Rear
EXTERIOR
BT-38
p
22
Back door finisher
NBF279
Nut x 8
EXTERIOR
BT-39
●
When removing or installing seats with side air bag module, be sure to disconnect or connect side air
bag sub harness connector.
●
When removing or installing the seat trim, handle it carefully to keep dirt out and avoid damage.
★
For Wiring Diagram, refer to “POWER SEAT” in EL section.
Front Seat
NBT048
18 - 24
(1.9 - 2.4, 14 - 17)
18 - 24
(1.9 - 2.4, 14 - 17)
18 - 24
(1.9 - 2.4, 14 - 17)
: N·m (kg-m, ft-lb)
21 - 26
(2.1 - 2.7, 15.5 - 19.2)
Instruction seat
Side airbag sub
harness connector
SEAT
BT-40
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст