Nissan Primera P11. Instruction — part 108
YEC103A
TROUBLE DIAGNOSES 17
CD20T
Brake Switch (Cont’d)
EC-137
INSPECTION START
(RDNT brake switch)
CHECK POWER SUPPLY.
1. Turn ignition switch to “LOCK” posi-
tion.
2. Disconnect RDNT brake switch har-
ness connector.
3. Turn ignition switch to “ON” position.
4. Check voltage between RDNT brake
switch harness connector terminal
p
1
and body ground.
Voltage: Battery voltage
OK
E
NG
Check the following:
●
Harness connectors
F104
,
M50
(RHD models)
●
Harness connectors
F2
,
E43
(LHD models)
●
Harness for open or
short-circuit between
RDNT brake switch
harness connector ter-
minal
p
1
and ECM
connector terminal
416
.
If NG, repair harness or
connectors.
CHECK GROUND CIRCUIT.
1. Turn ignition switch to “LOCK” posi-
tion.
2. Check harness continuity between
RDNT brake switch harness connec-
tor terminal
p
2
and body ground.
Continuity should exist.
If OK, check harness for short-
circuit.
OK
E
NG
Repair harness or con-
nectors.
CHECK COMPONENT.
(RDNT brake switch)
Refer to “COMPONENT INSPECTION”
on next page.
OK
Disconnect and reconnect harness
connectors in the circuit. Then retest.
Trouble is not fixed
Check ECM pin terminals for damage
and check the connection of ECM har-
ness connector. Reconnect ECM har-
ness connector and retest.
INSPECTION END
YEC377
RDNT brake switch
harness connector
YEC378
RDNT brake switch
harness connector
H
H
H
H
H
H
TROUBLE DIAGNOSES 17
CD20T
Brake Switch (Cont’d)
EC-138
COMPONENT INSPECTION
Stop lamp switch and RDNT brake switch
1. Turn ignition switch to “LOCK” position.
2. Disconnect switch harness connectors.
3. Check continuity between terminals
p
1
and
p
2
.
Continuity:
Brake pedal
Stop lamp switch
RDNT brake switch
Released
No
No
Depressed
Yes
Yes
If NG, replace stop lamp switch or RDNT brake switch.
1 2
1
2
YEC379
TROUBLE DIAGNOSES 17
CD20T
Brake Switch (Cont’d)
EC-139
ECM Relay
The ECM Relay shuts off the main power supply to the ECM
within 5 seconds after the ignition switch has turned to the
“LOCK” position.
Malfunction is detected when .
Check Items
(Possible cause)
●
ECM relay shut-off time is too late.
●
Harness or connectors
(The ECM relay circuit is shorted).
●
ECM relay
●
ECM
DIAGNOSTIC TROUBLE CONFIRMATION
PROCEDURE
1)
Turn ignition switch to the “ON” position and select
“DATA MONITOR” mode with CONSULT-II.
2)
Turn ignition switch to the “LOCK” position and wait
at least 5 seconds.
3)
Turn ignition switch to the “ON” position and wait at
least 2 seconds.
DIAGNOSTIC PROCEDURE
Refer to “Trouble Diagnosis for Power Supply” (EC-CD-59) for
ECM relay circuit inspection.
TROUBLE DIAGNOSES 18
CD20T
EC-140
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст