Nissan Primera P11. Instruction — part 328
Electrical Components Inspection
FUEL WARNING LAMP OPERATION CHECK
1. Turn ignition switch “OFF”.
2. Disconnect fuel level sensor unit harness connector
B31
.
3. Connect a resistor (172 - 180
Ω
) between fuel tank gauge unit
harness connector terminals
쑗
1
and
쑗
3
.
4. Turn ignition switch “ON”.
The fuel warning lamp should come on.
OIL PRESSURE SWITCH CHECK
Oil pressure
kPa (kg/cm
2
, psi)
Continuity
Engine start
More than 10 - 20
(0.1 - 0.2, 1 - 3)
NO
Engine stop
Less than 10 - 20
(0.1 - 0.2, 1 - 3)
YES
Check the continuity between the terminals of oil pressure switch
and body ground.
YEL455B
Fuel level sensor unit connector
172 - 180
Ω
resistor
MEL425F
Ohmmeter
WARNING LAMPS
EL-179
System Description
The warning chime is combined with the time control unit.
The light warning chime will not sound, when ignition switch in the ON or START position. (When power
supply exists at time control unit terminal
쑗
1
.)
LIGHT WARNING CHIME
With ignition switch in the OFF position, driver’s door open, and lighting switch in 1ST or 2ND position,
warning chime will sound. A battery positive voltage is supplied
●
from lighting switch terminal
쑗
12
or daytime light control unit terminal
쑗
6
●
to time control unit terminal
쑗
10
.
Ground is supplied
●
through driver side door switch
●
to time control unit terminal
쑗
6
.
WARNING CHIME
EL-180
Wiring Diagram — CHIME —
YEL348D
WARNING CHIME
EL-181
YEL881C
WARNING CHIME
Wiring Diagram — CHIME — (Cont’d)
EL-182
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст