Nissan Primera P11. Instruction — part 438
MODELS BEFORE VIN - P11U0559000
NFA056
Front
98 - 118
(10 - 12, 73 - 87)
Drive shaft
Baffle plate
Wheel bearing assembly
Snap ring
Inner grease seal
Snap ring
Knuckle
Wheel bolt
Disc rotor
Outer grease seal
Wheel hub
Plain washer
Wheel bearing lock nut
255 - 333 (26 - 34, 188 - 246)
Cotter pin
Wheel nut
98 - 118 (10 - 12, 73 - 87)
: N·m (kg-m, ft-lb)
: Apply grease
SEC. 400
.
18 - 24
(1.8 - 2.4,
13 - 17)
ABS sensor
FRONT AXLE
FA-9
MODELS AFTER VIN - P11U0559000
YFA001
FRONT AXLE
FA-10
Wheel Hub and Knuckle
REMOVAL
CAUTION:
Before removing front axle assembly, disconnect ABS wheel
sensor from assembly and move it from front axle assem-
bly area.
Failure to do so may result in damage to sensor wires and
the sensor becoming inoperative.
1. Remove wheel bearing lock nut.
2. Remove brake caliper assembly and rotor.
Brake hose need not be disconnected from brake caliper.
In this case, suspend the caliper assembly with a wire so as
not to stretch the brake hose.
Be careful not to depress the brake pedal, to prevent the
piston from popping out.
Make sure brake hose is not twisted.
3. Separate tie-rod from knuckle with tool.
Install stud nut inverted on stud bolt to prevent damage to
stud bolt.
4. Remove kingpin cap and securing nut. Separate kingpin from
knuckle.
5. Separate drive shaft from knuckle with drift.
When removing drive shaft, cover drive shaft boots with
waste cloth to prevent damage to them.
SFA897A
SFA898A
SFA899A
HT72520000
SFA907A
SFA900A
Wood
FRONT AXLE
FA-11
●
Remove ball joint securing nut. Separate from knuckle using
Tool (as for tie-rod).
INSTALLATION
●
Install knuckle with wheel hub.
●
Tighten wheel bearing lock nut.
: 236 - 313 N·m
(24 - 32 kg-m, 174 - 230 ft-lb)
●
Check that wheel bearings operate smoothly.
●
Check wheel bearing axial end play.
Axial end play:
0.05 mm (0.0020 in) or less.
DISASSEMBLY
CAUTION:
When removing wheel hub or wheel bearing from knuckle,
replace wheel bearing assembly (outer race, inner races and
grease seals) with a new one.
Wheel Hub
Drive out hub with inner race (outside) from knuckle with a suit-
able tool.
Wheel Bearing
When replacing wheel bearing, replace complete wheel
bearing assembly (including inner and outer races).
●
Remove bearing inner race (outside), then remove outer
grease seal.
SFA901A
HT72520000
SFA906A
SFA902A
SFA903A
Suitable tool
SFA654A
Suitable tool
FRONT AXLE
Wheel Hub and Knuckle (Cont’d)
FA-12
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст